Fedora :: F11 On Inspiron 6000 - Sound Lost Since Update
Jul 25, 2009
In the last week or 2 I've noticed something odd with the audio - but as I don't use the it very much and also accept all the ongoing updates from Fedora. Anyway symptoms are (using ALSA):
1. Volume control button on the laptop - when decreasing to less than ~50% the sound goes to zero.
2. Watching flash movies (in Firefox 3.5.1, Adobe 10 plug-in) (e.g. BBC, .....): they play fine for a few seconds then go choppy (audio and video) then video recovers but sound is lost (and the laptop volume control does not work at all after that).
3. Finding similar problems on replay of audio with kplayer and vlc on music files (ogg) that previously worked fine.
I've seen the pulseaudio and vlc fix thread but I don't use pulseaudio in kplayer, for example.
I installed Ubuntu 10.10 on a Dell Inspiron 6000 but when I connect the ethernet cable the computer detects that the cable was connected but doesnt connect to the internet.
I just installed open suse 11.2 on a dell inspiron 6000 and i can not get the wifi card to work. Yast sees it, but that's about it. Ethernet works fine- hence the post.... any ideas? Model: intel pro wireless 2915abg calexico2.
I am still a noob with linux and debian in particular. I do some android development so through that I have learned a little bit about linux but only the basic command prompt commands and the basics of how linux works and such.Anyways, I was looking around on the forum and on other forums and I couldn't find any helpful information about how to set up wireless connections (such as wifi) on debian. When I installed debian on my computer it asked me for the ipw2200 files and I didn't have them at the time but now I have the latest framework files for that, I don't really know how to install them and after I install them I don't know how to turn on my wireless connections from there.
I am really sorry if someone already made a post on this subject and I am just too clutzy to find it, if that's the case please just post the link to that thread for me cause I'm dumb as crap.So basically the main problem I am trying to fix right now is that I cannot get my internet to work on my old dell inspiron 6000 laptop which I am trying to get to run debian.
I am running Natty on a Dell Inspiron 6000 under dual boot. Now Ubuntu refuses to load. GRUB goes along to a point where the final message in both regular and recovery modes is 81.8921591 atal: SRST failed (errno=-16). Is there any way I can recover short of having a professional rescue my data from the hard disk and totally redoing the install. I have had this problem in previous versions but never fatally before. My computer works fine under Windows.
Under 10.04, I was using my sound card just fine, but after a system update,I lost all my sound profiles and my sound. I'm using my mobo's SPDIF ( I have an ASUS p7p55d).
I have had such good sucess with Ubuntu that this took me by surprise. Last week after an update I was suddenly without sound in Karmic Koala. Fortunately. I also have Lucid Lynx and the sound is OK there. I really gave it a dedicated try but was unable to get any sound.
I have a problem with sound. I have 2 boards that I can select from 1 internal 1 external for Ham radio. I was on a program that I was trying to get updated Fldigi. And now I lost the sound. My bad I now know. Here is a picture of what I see when I go into the System/Preferences/Sound
I just lost the sound to Xine after updating Hardy. It works fine otherwise and I have sound with Totem and VLC so it would seem to be a Xine-only problem.
I installed REL 5.5 on this Dell laptop (originally win 7) and everything works ok except when i get to the login GUI the LCD brightness (or lack of) sets to it's lowest so i have to click the f5 button to brighten the screen. If I log out, the LCD resets to the dimmest setting (can hardly make out the login GUI) and again I have to click on f5. I believe I need to update the BIOS but I don't know how. The BIOS update I dound on-line if a xxx.exe file.
I don't know what I did but I lost all audio. I'm running F15 with gnome 3. By opening system settings and then sound I don't find anything muted. Under hardware I have 3 devices, the first is RS880 Audio Device (Radeon HD 4200) this one has no sound at all when I click test speakers. Then I have quickcam comm STX and then I have Internal Audio which works by clicking on test speakers.. I have no clue of where to start to fix this but reinstall everything again.
My wife's laptop is Dell Inspiron 6400 running 11.04. Wireless has recently stopped working. Running rfkill list all shows dell-wifi hard blocked no soft blocked no. The fn plus F2 keys toggle status between blocked no and blocked yes, but network manager still can't see network. I've tried removing the Broadcom STA driver - no joy.
I updated my computer Wednesday (01-20-2010) and excluded three mesa... files and one xorg... file. I had recently read that people were having problems with these particular updates and I wanted to address them separately (to isolate any problems I may have). I think I may have screwed things up by accidently including the libdrm file. This file was previously missing for the mesa updates. The update I did included several plymouth... files also (don't know if it matters). Now I have a black screen with a cursor, after the fedora (charge) logo completes.
If I hit Ctrl-Alt-F2 I can get a login prompt. I logged in and tried to go back and update (as root) the four files I had excluded, hoping to fix the problem. Now I am getting the following errors during the yum update. The first two lines are repeated several times. I can't scroll back to see what's at the beginning.
After I installed the new Fedora 13, all went well without problems.
Unfortunately, the sound settings are not retained. That means after a reboot, I have to set this again and again.
I have an: HD 5.1 Intel OnBoard Sound Card. I run "gmix" or "kmix", the rear wheels boxes are always "mute". I put on this, but after the restart the setting are lost.
The PulseAudio settings are set to 5.1 Digital Sound.
What can I do to go the the settings are not lost?
I have just upgraded to Fedora 14, with some hope that a F13 kernel crash issue would be resolved. Alas, not, and I have lost audio in one of my sound cards. I am using 2 sound cards in my computer. The first one (VT 1708 on the M2V MX SE motherboard) is used for FLDIGI (ham radio program). The other one (Creative Labs SB Live!) is tied to a speaker/microphone. At some point in mid 2010, I started getting kernel crash reports (not sure which kernel version this started), and the VIA VT 1708 audio controller stopped working. The SB Live! card works fine.
From mesg, I get: [9.181148] WARNING: at drivers/pci/pci.c:105 pci_ioremap_bar+0x2c/0x5b() [9.181186] [<c05c36ad>] ? pci_ioremap_bar+0x2c/0x5b [9.181194] [<c05c36ad>] pci_ioremap_bar+0x2c/0x5b [9.181299] ALSA sound/pci/hda/hda_intel.c:2510: ioremap error
I've just pulled out the SB LIVE! card to see if it is causing the VT 1708 controller to fail...there appears to be no interaction.
From lspci -v, I get: 20:01.0 Audio device: VIA Technologies, Inc. VT1708/A [Azalia HDAC] (VIA High Definition Audio Controller) (rev 10) Subsystem: ASUSTeK Computer Inc. Device 8290 Flags: fast devsel, IRQ 17 Memory at <ignored> (64-bit, non-prefetchable) Capabilities: <access denied> Kernel modules: snd-hda-intel
So it seems to know it's there. How to get my sound back (and get rid of this kernel crash every time I start my computer)?
How may I slow down the mouse scroll speed in F10? When I use the scroll wheel, a mere fraction of a turn and I am zooming through a page. I already tried changing some settings in Firefox, per another posting on scroll speed. It did not seem to work.
openSUSE 11.2 64bit libxine1 from Packman 00:14.2 Audio device: ATI Technologies Inc SBx00 Azalia (Intel HDA)
Maybe it's just an Amarok2 problem, but whenever another app (for example Konversation) plays a sound file, the audio instantly cuts out (in Amarok2) and will not come back unless I quit Amarok2 and restart it.
Amarok2 has only the options - "HDA ATI SB VT 1708S Analog" or "PulseAudio" (which is NOT installed).
alsa-info here - [URL]
Also I am totally confused by the mixer, it has so many knobs that I am totally lost!
Initial FC12 install worked great, kernel 2.6.31.5-127.fc12.x86_64 allowed radio kill switch functionality Fn-F11 for wlan and Fn-F12 for bluetooth.The last two kernels have broken that functionality.
Just got a Dell Inspiron N5030. Internal speaker works. I can make a skype test service with internal speaker device. When I plugged the head phone, the head phone does not work. No problem with the head phone indeed. I have searched the forum for N5030 key word. But never able to find one.
I am using Ubuntu 10.04 LTS
- the Lucid Lynx - released in April 2010 and supported until April 2013.
I have made sure the card is not muted using kmix, alsamixer, and running alsaunmute 0. It was working for some time and just stopped. I am not sure if getting rdesktop to work on the laptop caused the issue or not since that seems to be the last major thing I did. (missing my sipie.py). This is what I am working with:
~]$ uname -a Linux xxxx.xxx.xxx 2.6.18-128.7.1.el5 #1 SMP Mon Aug 24 08:20:55 EDT 2009 i686 i686 i386 GNU/Linux ~]$ lspci 00:00.0 Host bridge: Intel Corporation Mobile 945GM/PM/GMS, 943/940GML and 945GT Express Memory Controller Hub (rev 03)
I wanted to hear some music from my audio library, so I turned on banshee, all the sudden the audio started to hear choppy, no unusual disk activity, no slowness of my laptop. I restarted the laptop since, I had a big Red buton that asked for it. After reboot tried listening to my music and the same result choppy audio. Tried rebooting again, same thing. Has anyone experienced this issue with audio after todays update? My laptop is a Lenovo Thinkpad t61 2 GB RAM and fedora 11 x_64
I am working for Fedora 12 installed on my laptop, and skype has worked. I was able to speak, able to listen and everything (besides some installation problems) was working fine.
Then I allowed Fedora to update(or bugfix or enhacement) some items of my system.
Now when I click on the loudspeaker symbol in the panel and open the mixer I see various tabe for sound input and output. Finally a good idea, and I even have a slide for skype!
But it does not work, I don't hear anything from skype (version 2.1.0.47).
I am able to record and playback via arecord/aplay, so in principal it should work. Any ideas what is wrong? Maybe a bug in a bugfix?
Before going to sleep I just closed my laptop without shutting down, but the next morning when I unlocked I had no sound. Does anybody see something suspicious in the updated packages?
I have had no sound on my thinkpad x40 for a week now, first with f12 and now with f13. Under f12 I had sound until about 5/26/2010. I first noticed I had lost sound after some updates around that date. After not being able to solve the problem, I upgraded to f13, but still no sound.
pulsesound seems to be working. If I run pavucontrol and go to the playback tab, and then run paplay /usr/share/sounds/k3b_success1.wav from a console, it registers on the pavucontrol tab, but I hear nothing. kmix shows nothing muted. alsamixer shows nothing muted. pavucontrol shows nothing muted.
