Hibernation on my laptop doesn't work. When I try to hibernate (either manually or automatically because battery goes critically low), any of the following can happen (randomly):
A. During the hibernation process it hangs forever with a black screen (with or without some error messages unanderstandable to me) and never terminates hibernation. I have to manually turn it off by holding the power button, and when I turn it on again, it does a fresh boot.
B. Instead of hibernating, it just locks screen.
C. It (apparently) terminates the hibernation (the power goes off automatically as if it had succesfully hibernated, even if AC power is connected), but then, when I turn the computer on, instead of resuming it does a fresh boot.
D. It hibernates succesfully and when I turn it on it resumes succesfully. This almost never happens; it has been a long long time since the last time it happened.
I am far from being the only one and this has been so for years. The bug has been reported in launchpad by a lot of people a long time ago, so if it has not been fixed in such a long time it must mean that the developers don't think it deserves much attention. (Which is strange by the way, because an operating system with non-bulletproof hibernate/suspend is an operating system that you just cannot safely use, at least on a laptop.)
After the upgrade, I've noticed a problem I haven't had before - hibernating worked fine to the last. The problem is, although the system correctly hibernates, it makes no attempt to "wake" from hibernation when I power it up - it boots normally, and with fsck-ing like it was powered off without proper shutdown (understandably). I don't know why it happens, and I've skimmed the logs, but noticed nothing special. What could be the problem? What could I try? Which log should help someone find that out?
I have installed VirtualBox and since then resuming from hibernation doesn't work again (my previous thread: [URL] ....). My question is: Can VirtualBox kernel modules (vboxpci, vboxnetadp, vboxnetflt, vboxdrv) break hibernation? If yes, what to do? Maybe unload them before hibernation, blacklist when resuming and load after resume? And how to do that with systemd? URL....
I use ubuntu 10.10 and for some reason the sound doesn't work. tried everything reinstalling ALSA and alsa driver doesn't even work any help, it's a toshiba satellite L505-S6946
I just installed Ubuntu 10.10 I love it. The only problem is my built-in mouse doesn't work. My usb mouse works fine but not the built-in one. When i was installing Ubuntu i used the USB mouse, The only problem is my mum needs it for her computer.
So, I jaibroke my iPod touch and have OpenSSH and I can ssh into my iPod, but I cannot ssh back into my Laptop??
I did
Code: $ echo '192.168.*.*' >> /etc/hosts.allow ##I googled and it said to do this $ echo 'sshd: 192.168.*.*' >> /etc/hosts.allow I also uncommented these lines in /etc/ssh/sshd_config:
[Code]....
I am 100% sure I am putting in the right password. I even did that ^ code from my laptop, the one I am ssh'ing into, but it still will not accept my password. I even tried root@ instead of matt@..
The cooling fan on my Toshiba Satellite m500 doesn't work after installation of ubuntu 9.10. I've looked on the internet but i can't seem to find anything.
I have installed it in multiple machines (servers, desktops, laptops)I have even installed 10.04 beta in several laptops for educational purposes without a single crash. But 10.04 crashes in laptop ASUS X50GL with processor Intel Core 2 Duo T5800.In fresh installation, it hangs always, in ANY 10.04 version, beta or stable, 32 or 64 bit, also from iso image in CD or in usb stick,I have tried all possibilities!Therefore, clever enough, I though let's do it in an indirect way: let's install the 8.04 distro (it works) and later on I will upgrade to 10.04. So I just did.Everything was fine (also the upgrade, without a single warning) until final reboot after upgrade to 10.04.hanged at boot!. There is incompatibility between 10.04 and this firmware, clearly. Unfortunately, 10.04 is not yet stable, I guess.I took a picture of the screen which I attach.
After upgrading from 9.04 to 9.10 internal subwoofer on my Acer Aspire 5930G laptop stopped working.
UPDATE and FIX: Problem was fixed after upgrading to ALSA 1.0.22 using instructions from this topic: http://ubuntuforums.org/showthread.php?t=1046137 NOTE: be sure that ALSA driver was really updated using this commmand: cat /proc/asound/version, if not, see these posts: problem: http://ubuntuforums.org/showpost.php...&postcount=670 solution: http://ubuntuforums.org/showpost.php...&postcount=678
I am using a old laptop as a server now and its running great! I would like to disable sleep/hibernation when I close the lid (i would prefer the screen still shut off if possible) ...
This has to be done via command line because I don't use a gui ...
I bought a new CDROM drive, as recommended by HP. It still doesn't work. I can open and close it now; so that's changed. But it still doesn't appear as a drive, and I can't use it.
Here's as best as I can describe it:
When starting up, the boot order doesn't recognize the cdrom drive, but I can open and close the drive during this time.
In Windows 7, I can't open the cdrom drive, and it doesn't recognize it in device manager, disk management, or my computer.
In Ubuntu Linux, I can open the cdrom drive, but it still doesn't recognize the cds, and it won't mount.
If I reformat everything, would my cdrom drive work again? Can I reinstall Windows without a cdrom drive? I've deleted the upper and lower filters as was suggested in Google searches. Took the disk drive out and checked that it was installed correctly (no reason it shouldn't have been). Still: nothing works.
How to make the mics work on a Dell XPX M1330 laptop. This seems to be a common problem with built in mics on laptops. I've tried all the obvious things with alsamixer and pulseaudio.
I have a laptop Acer Aspire 4551-2194. I've installed Debian Squeeze with XFCE and it works great. I have only one problem. I can go through hibernation / suspend, but when I push the power button, the computer hangs. It doesn't come back and I must reboot it.
I got myself a shiny M305 Logitech mouse for my laptop. It comes with a littlee USB wireless dongle. When I plug in the dongle, DMESG shows me that the system notices the dongle:
usb 5-1: USB disconnect, address 6 hda-intel: IRQ timing workaround is activated for card #0. Suggest a bigger bdl_pos_adj. usb 5-1: new low speed USB device using uhci_hcd and address 7 usb 5-1: configuration #1 chosen from 1 choice input: Logitech USB Receiver as /class/input/input15
I am playing with SalixOS which is supposed to be entirely compatible with Slack. I've never put Slack proper on this laptop. It's run Ubuntu and Mandriva both and the volume wheel always works. It does not seem to be recognized in Salix. I figure the fix will be the same in Salix as Slackware so I'm asking here. The laptop is an A205 Toshiba Satellite.
My suspend-to-disk and suspend-to-RAM stopped working months ago. I've grasped at straws about why ever since, but I really don't think it's a software problem, because I've reinstalled my system (MEPIS) repeatedly. What sort of hardware failures could cause this? What should I be looking for? I notice that at boot, Linux always says "no resume image found," even if I left the system in suspension or hibernation. I can post parts of the dmesg if someone tells me what to look for; I can't display the whole thing because it's too long to fit here.
Recently I have installed Fedora 14 on my other laptop. It's a dual boot with Windows 7. Everything worked perfectly fine, networking included, until my friend didn't accidently turned off the wireless by pressing a wireless button on the laptop. Since then the wireless on Fedora doesn't work. It does on Windows thought. I've tried restarting the laptop few times, but the wireless still doesn't want to work again.
I'm using 'Adobe Flash plug-in 10.3.183.4ubuntu0.11.04.1', installed from the package repos on kubuntu, and since the last update, it has broken all flash functionality in both rekonq and firefox.I have tried removing and reinstalling the package multiple times, both with and without the browsers open. Can anyone suggest a way to restoring functionality?
When I installed my 64 bit system of Ubuntu 10.04 the sound worked very well and I were very happy. The problem started however when I installed Skype which uses pulseaudio. As soon as I start skype (or any other application that uses pulse, HoN for example) the applications sound output or input does not work at all. If I have pulseaudio started in some way, applications that I suppose do not use it like spotify or flash player stops to produce sounds. And when I type "pulseaudio" in the terminal it gives me this:
I'm having trouble getting compiz to work on my Laptop. It worked for a while and then I turned on Shift Switcher and a message popped up saying..."The new value for the button binding for the action Terminate in plugin Shift Switcher conflicts with the action Zoom Window of the Scale Addons plugin. Do you wish to disable Zoom Window in the Scale Addons plugin?" I was given the option of Set Terminate anyway, Don't set Terminate, and Disable Zoom Window. I clicked Don't set Terminate and ever since the only thing that works in compiz are the bindings in the general options. I've used synaptic to completely remove and then reinstall compiz but the problem persist. Something else weird, all of the changes I made are still there, even after complete removal, but they don't work?
When I try to hibernate, the computer just goes to a blank, black screen and doesn't turn off. I have to hold the power button to get it to shut down, and when I turn it back on none of the programs running before hibernation have been saved.
I just recently (about an hour ago) installed Ubuntu Netbook edition on my old laptop, and I was greeted with the message, that unity could not be run due to some sort of missing driver...fair enough, I was then greeted with the default Ubuntu desktop, I installed all my needed software (wine, google chrome) and installed the missing display drivers. I then rebooted the system, and once again I am stuck with the default desktop, and not the Unity interface. I checked the software center, and it says Unity IS in fact installed.. And yet I cannot make it appear. So now I ask you Ubuntu veterans. How do I make it work?
P.S. I wiped the system of windows, and the computer is an old HP Pavilion DV6000
I have this annoying problem since day one.I am testing out Red Hat RHEL5, everything is fine except DNS look up.If I ping www.google.com, it doesn't work, ping ip address it all works;if I bring up browser, put www.google.com it doesn't work, can't find the name, however, simply put ip address there it works.My DNS seeting seems ok, and the DNS works from Windows box.
I have samba network sharing working between an ubuntu box and an xp laptop. xp laptop does not need login when booting up. however, a vista laptop does not even show-discover the ubuntu machine the vista laptop you logon with a password to use when booting up. both xp and vista laptops are on the wireless LAN and the ubuntu box is on the wired LAN. internet works on all 3 So what to do with vista box to make it even see the ubuntu box? Vista laptop did discover several upnp softwares running on the ubuntu box, but does not see the ubuntu shares, etc
I'm currently having problems trying to install Ubuntu on my laptop.I have burnt off a CD that contains the latest Ubuntu 10.10 iso using the exact way the website tells me to.However, I can't boot from that CD. I can, however, boot from other CD's. For example i ran my Gparted Live CD to create a partition on my hard drive about an hour ago and that worked fine.
My laptop doesnt support USB booting, has no optical drives but does have an FDD.If copy the install folder onto a USB drive, boot from a floppy and load USB drivers for the drive, can I then install from there without issue?
