For the first time, after hibernating, I was unable to use the wifi card. I had to reboot again. These are the ouputs of common commands after bringing networking down, up and down again:.
[Code]....
I have installed Ubuntu for netbooks on my four year old laptop and of course the wifi card is unable to search for wireless networks when I'm booted into Ubuntu. I do have the driver software on a recovery disk. Would installing it in Ubuntu fix my problems?
View 4 Replies View RelatedI cant seam to find out how to get my card to work i cant find out how to install the driver or finding the wifi card on the system.
View 9 Replies View Relatedget WIFI working on my Dell D600 with Ubuntu 11.04 freshly installed. I some limited sucched following the this post t=1621331 this got the card working but it was very very slow over 70% packet loss to the WIFIrouter. 1. Machine details Dell Latitude D6002 Wireless Broadband and Chip setlspci -nn | grep Broadcom - 02:03.0 Network controller [0280]: Broadcom Corporation BCM4309 802.11a/b/g [14e4:4324] (rev 02)3. Check interfaces
eth0 Link encap:Ethernet HWaddr 00:0b:db:e0:1c:5b
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
[code]...
I am running (K)Ubuntu Lucid 10.04 64bit on a Dell Latitude E6400, WiFi Card Intel 5100. Never had any problems with networking. Up to about 2 weeks ago. I do realize there have been quite a few posts with this network adaptor, but non really described the problem I have here.
What happens is that suddenly the WiFi LED on the computer stops blinking, the WiFi connection gets disrupted, and the device is not recognized anymore when checking ifconfig. Only cold restarting the machine helps then... it will work for a while (between 1 and 20 minutes) and then crash again.
On Windows 7 the card works perfectly fine. With Ubuntu 11.04 in Live CD mode I have the same effects (connection crashes after a while). Also tried booting an older kernel, no success.
My exact hardware:
Code:
I notived the following problems in /var/log/kern.log
Code:
As a part of my final project,i am beginner and this is the first one that i have the opportunity to work under linux fedora,my task consist to develop with C a driver of wifi by using the SDIO Wifi card as an interface. This driver will be included in a digital receiver TV.
View 2 Replies View RelatedI'm sure you've seen this question before -- I tried searching but I can't find a clear answer. All I need is to get my wifi up and running in Ubuntu 10.04. I'm currently double-booted with XP on a Dell Latitude E5400 laptop. I'm in Windows right now. I can't post my lpsci readout because I can't access the internet from Ubuntu -- no access to wired connection.
I worked on this problem for a long time last night and fixed it somehow by installing a driver program -- it had "cutter" in the name. Today, however, I try to log in and Ubuntu won't connect to an open wifi point. Boot #1 it recognized it but wouldn't connect. Boot #2 it wouldn't recognize it at all (said "wireless is disabled" even though it wasn't. Boot #3 it would recognize the wifi point but wouldn't connect.) I can mantain a constant connection to this wifi in Windows XP and also on my Android phone.
I just want someone to please tell me how to get my wifi working reliably. I'm excited to switch over to Ubuntu, all I need is for the wifi to work. My wifi card is a Broadcom 43xx (4312?). Something like that.
Ubuntu 9.04 running on a Dell C640 with a Dell TrueMobile 1150 wireless card. Works perfectly under XP. Ubuntu can't find it. Wired networking finds the internet perfectly (though I'm still working on getting samba set up correctly for file/print sharing on my XP LAN).
I'm thinking I need a driver, maybe? Can't seem to locate one.
i just thought the last few days about trying Ubuntu. so i did. i got a nice and fresh copy of Ubuntu Desktop version and installed it, everything worked great except my wireless usb 2.0 card. the only internet connection i have under windows is Wifi and i hoped that my dongle will be recognized by Ubuntu automatically...(naturally, it wasn't the case.)
so my adapter looks exactly like this one here, except for the color, it's white and it has my WISP's name written on it (i got it from them, along with a cd that offers win xp/98/me drivers...)
so even everest sees it's atheros and it's the Atheros AR5523 chipset.
i also have windows 7 64bit drivers if they help...
anyway, i can't get it to work and cannot access the internet any other way when on Ubuntu, so i have to use an already-saved driver..
i installed Ubuntu 10.10 on my desktop computer, the live cd worked fine. my wifi worked there. but after installation completion i didnt get any screen. all black. nothing after the grub menu. i dettached my TP-Link TL-WN353G wireless PCI card and it worked fine. now what to do?strange, the wifi card works fine on Ubuntu Live CD and on win XP. please guidei have tried deleting quite and splash during boot upduring boot i pressed 'e' and deleted quite and splash and then ctrl-X but still the same result. the screen goes black. no graphics after grub menu.
View 2 Replies View Relatedmy bcm 4312 wifi card gets disabled after each reboot, now that ive installed compat-wireless patched for mac 80211 frag attack... in order to get my wifi card fired up again i have to browse tom my compat-wireless source folder in /home/user/Downloads/compat-wireless and issue the commands sudo make wlunload and then reload my wifi driver via sudo modprobe b43. is there any way to fix this problem? or furhter troubleshoot here is what dmesg says on boot:
Code:
[ 22.425475] b43: disagrees about version of symbol ssb_device_is_enabled
[ 22.425481] b43: Unknown symbol ssb_device_is_enabled (err -22)
[ 22.432766] b43: disagrees about version of symbol ssb_pmu_set_ldo_paref
[code]...
i was wondering how to get the above wifi card working as it is not supported.
View 1 Replies View RelatedI have downloaded the driver installed it, and it works fine. But i can't get to turn it off. I do have the ability to unload the driver's kernel modules and the sysyem does not see my card after that. That's ok, but i'm thinking it still uses my battery power. The wifi led is always on no matter what i do. The fn+<wifi key> doesn't to anything.
View 8 Replies View RelatedI'm having a problem with my wifi card: it is not detected by the network manager. I have tried going to the Hardware Drivers utility, but it doesn't find any proprietary hardware.I really am at a loss as to how to make Lucid "start over" with the wifi detection.I have installed Lucid using an existing /home, which was under 8.10. Maybe i just need to wipe out some configuration files to start afresh?
View 9 Replies View Relatedi installed ubuntu on my friends laptop but when he tries to connect to his network and enters his wep key the box disappears for a few second and comes back again...The card is Atheros on a Toshiba laptop and it is detected , it finds the networks but the wep key is rejected every time without a error
View 5 Replies View RelatedI've just installed Ubuntu 10.04 on my old X30 alongside my fully working 8.04 and have strange wifi problems under 10.04 (under 8.04 it worked out of the box):
- no available networks are shown
- running "sudo iwlist scanning" results in "eth1
Interface doesn't support scanning : Device or resource busy"
- without any wireless configuration from my side I get this:
sudo iwconfig eth1
eth1 IEEE 802.11b ESSID:"gxC6isQxFFJxEC)xCDxBAxAB
xF2xFBxE3F|xC2TxF8x1BxE8xE7x8DvZ.c3x9FxC 9x9A"
Mode:Managed Frequency:2.467 GHz Access Point: None
Bit Rate:11 Mb/s Sensitivity:1/0
Retry short limit:8 RTS thrff Fragment thrff
Encryption keyff
Power Managementff
Link Quality=90/70 Signal level=-8 dBm Noise level=-147 dBm
Rx invalid nwid:0 Rx invalid crypt:63 Rx invalid frag:0
Tx excessive retries:1 Invalid misc:0 Missed beacon:0
A very strange ESSID there appearing out of nowhere...
This is the issue, and I have had this happen with a few card readers. I have a Alfa Usb Wifi adapter model number AWUS036H using the rtl8187 Chipset. It works fine, unless I plug in my flash card reader directly to the board. If I plug it in to a hub it works fine until I put a card in, I was also having the same issues using a USB Video Capture unit by the name of EASYCAP. This was also happening in XP. Must be some driver conflict of sorts.
View 1 Replies View RelatedIs there a way to see the manufacture of wifi router/card remotely like "inSSider" shows, for example ???
View 2 Replies View RelatedIm looking for a pci wifi card for my media pc, I would prefer wired, but we are moving soon , so i dont want to take the time to run a wire through the house. Im looking for one that will work out of the box with Ubuntu.
View 1 Replies View RelatedI'm running Joli Cloud 1.2 on my HP dm1z netbook and for some reason, it doesn't seem to recognize my wireless card. Because the HP dm1z has no ethernet port, I had to use a USB adapter to connect to the internet.
View 2 Replies View Relatedso I had to reinstall Ubuntu.But now my Wireless card won't work. It used to work before (plug and play), and I have no problem with it when I boot from the CD.I cannot use my cable connection because as soon as I plug my computer in, the network crashes, the router doesn't respond, gets hot and refuses to work until I unplug it and let it cool off for 2 minutes.I'm using Ubuntu 10.10, Desktop PC.
Code:
:~$ lsusb
Bus 001 Device 002: ID 0846:4260 Netgear, Inc. WG111v3 54 Mbps Wireless [realtek TRL818B]
[code]....
Reading recent posts, it seems that 11.04 has seriously screwed wifi.
I have an Advent QRC430 laptop which worked perfectly until I upgraded to Natty. Now wifi is broken. The wifi driver is rt73usb.
When I run lspci in terminal, no wifi card is listed. Running rfkill shows wifi hard blocked, but the switch on laptop makes no difference.
I've installed and run Hardware Lister - this shows wireless interface "has been disabled"
I have discovered the world of freewares not long ago and it surprised me! To go a bit further, I have installed Lubuntu 10.4 LTS on an old laptop: HP Pavilion zv5326 with 256 Mo RAM.
Everything works fine except the wifi.
iwconfig returns for wlan0:
IEEE 802.11b ESSID:"Livebox-afe5"
Mode: Managed Access Point: Not-Associated Tx-Power=0 dBm
Retry Long Limit:7 RTS thrff Fragment thrff
Power Managementff
Ifconfig returns nothing for wlan0
From what I understand, my wifi card is recognized so I do not need to install a driver with ndiswrapper, right?
What should I do then? Is there a solution at all?
(Livebox-afe5 is the wifi connection I use with my other laptop.)
I booted Debian in Live mode on a USB to try to see if the internet will work on my Linux machine before I actually install it (there is some tricky internet software where I live that I must overcome, but that will come in another thread).
Currently I have no WiFi whatsoever. When I go into the internet access menu I only get back the fact that there is a wired connection that's possible (theoretically, I should be able to also see networks to which I can connect to, but I don't). Also, it's impossible for me to actually get a wired connection going, unless I can somehow give it through my Windows laptop.
When I did some research, the people seem to say that I need to update the driver after enabling the use of non-free software; I can't do that since I have no connection in the first place.
The OS recognizes that the PCE exists (I am using asus pce-ac68), when I did "lspci" command it told me I have BCM4360 and BCM43225 chips.
I think I found the drivers here "[URL] ......" but I don't think my chip is listed there (there is no BCM4360 or BCM43225 on that list). What to do with those drivers, I mean how to compile them and install them on a Debian machine, and I'm not sure I can even install them on a live boot (but I want to make sure my internet works on the live boot before I actually install the OS).
I just installed Debian on my hp dv6205us. I have a bcm94311mcg Bradcom wireless card that is not detected. How do I get this working?
View 3 Replies View Relatedi am trying to install asus usb wifi card WL-167g v3 in fedora 14. but i am not able to install it properly.
View 4 Replies View RelatedHow do I get to remove ("hot remove") PCI WiFi card?
View 4 Replies View RelatedI got a new EDUP Wireless Lan PCMCIA Adapter to replace a busted SMC wifi card. I am running Ubuntu 9.10 on a Dell laptop. The OS will not recognize the new card. Here is some output code...
View 1 Replies View RelatedFinally took the plunge and upgraded my ubuntu studio to karmic from jaunty. I seem to be experiencing a problem many have, being that my wifi card (edimax) which worked on my previous distro is now not working at all. I've done a lot of research and found the problem seems to mainly be with broadcom cards, and have tried a number of things relating to those that have worked for others, with no luck.
My problem seems to be not that the drivers wont activate or anything like that, my problem is that under hardware drivers nothing appears at all. I have no drivers present, where most people are talking of 3. i have not found anyone else with this problem. My problem is compounded in addition by not being about to use a wire connection at all.
My wireless card isent detecting my router even though it has detected my 3 of neighbors wifi. the only reason i thought that it may not be able to detect mine is that i use a wpa2 encrption rather then a wep like my neighbors. so i tried to go and reset my router using my other desktop and set it to a wep encryption, but for some reason my computer still did not detect it. i am using a dell dimension comnputer with both a linkseys N gigabit router model number :wrt310n and the reciving card linkseysduel band wireless N network adapter model number :wusb600n. can somebody please tell my what i am doing wrong? this is rather annoying as i have to drag my desktop and moniter out to the living room just to physically connect to my router to enable internet.
View 1 Replies View Related