Ubuntu Networking :: 10.04 Cannot Connect To The Network - Wired Or Wireless
May 5, 2010
I have just installed Ubuntu 10.04 on an HP Pavilion dv6000 series laptop, dual-boot. Everything is working except the networking. It can see wireless networks, and when I type in the password for my wireless network, it tries to connect, then asks for the password again. When I plug in the Ethernet cable, again it tries to connect, but after a few seconds gives up and tells me I am now offline.
I am unable to connect to any network, wired or wireless. Network-manager and wicd are both gone, as in no longer installed. Please don't tell me to apt-get anything. I have no network connection. I have tried downloading packages for nm onto a usb stick only to find myself in dependency hell which ended with the impassible error "Requires installation of untrusted packages".
I have a laptop with Ubuntu 9.04 on it. I wanted to try out fluxbox, so I did a apt-get install fluxbox. When I went into fluxbox, I was having trouble getting connected to my network wirelessly. I saw a post online that said to install wicd. So I did a apt-get install wicd. This removed the Gnome network manager (nm-applet) which I didn't realize that it would do. I removed wicd when I saw this is what happened, and now I can't connect to a wired or wireless network. I tried connecting to my wired network, and I ran
Code: sudo ifconfig eth0 192.168.1.115
but I still can't access the internet, or other things on the network.
I've just installed 11.04 Natty on an old Laptop (Dell Lattitude C400) and am unable to connect to my home network (wired LAN connection, no wireless). The laptop previously had WinXP installed and was able to connect (I have also double checked the cables and ports and they're all functioning ok).
in linux world and have recently downloaded and installed ubuntu desktop 10.10i cannot connect to both wired and wireless ethernet on my laptopit tries to connect but fails in 30 seconds , it says"disconnected" while i am able to connect to the same in windows i have broadcom 4315 and i have tried both fwcutter and ndiswrapper but the problem persiststhe device id is 14e4:4315
I just did a fresh install of ubuntu studio 10.04 and I can not connect to either a wired or wireless network. The In Network Tools the IPv4 IP address is 127.0.0.1. It is plugged into a network giving out DHCP IP's. Both wired and wireless were working on ubuntu 9. I have tried to bring eth0 up in the terminal but it did not give an error or anything. It it running on a Dell Latitude D820 laptop.
I have recently developed a problem with my computer connecting to the internet which has totally stumped me and is currently forcing my to use windows much to my frustration. I am using ubuntu 10.04 on a Toshiba Satellite laptop. My wireless and wired network connections will not connect. They are all present in the menu and i can click on them but the connection tries to connect and then just times out and fails to connect. Everything still works fine in windows Vista. The more confusing thing is i tried some live disks to see if they would work but they all did exactly the same thing including a live disk of ubuntu 9.10 which used to work perfectly and live disks of openSUSE 11.4 and Mint 10. I struggling to tell if this could be a hardware problem or not. The fact that the live disks wouldn't work suggests a hardware problem but the fact that Vista still works totally throws that argument. I have looked all over these forums and elsewhere and have found some similar ish problems but non seem to have the severity of this one as all of those seem to be wireless only problems. The only thing that i was doing at the time this started was i had just set up a new secondary user account but i suspect that may be coincidental.
I installed ubuntu 9.10 on my laptop a few days ago and love the OS so far. However, initially i could only get internet connection though an ethernet cord. After much internet searching, i finally figured out how to get wireless internet. Unfortunately, in setting up wireless internet, I no longer have wired internet. The system doesn't seem to recognize my wired internet anymore. I'd like a scenario where i can connect to the internet both wired and wireless.
Yesterday I moved my modem (wireless) to my living room so the PS3 detected a better signal. In doing so, I had to run a new ethernet cable from my living room where the modem is into my office where the computer is. I use ubuntu 9.10
For some reason I cannot connect to the internet now. When I scroll over the connection, it says wire connection 1 is active. I have my settings manually set. I did notice the MAC address field is blank...
I didn't have an issue before, but with changing cables and whatnot, something got messed up somehow.
I'm trying to install Ubuntu 10.04 on my Toshiba A200-12U laptop (with an Atheros AR5007EG wireless card), but networking is being problematic.I entered Network Configurations and tried to get 'Auto eth0' working -- I went to Edit > IPv4 settings and filled in 'Addresses' with the details of my connection:
Address: 192.168.1.254 (the local IP of my router) Netmask: 255.255.252.0 Gateway: 18.104.22.168
cannot connect to my window computer using open SuSe
I am attempting to connect to my Windows Computer via a wired network on a sky router. When I tried with PClinuxOS it configured automatically. With the latest version of open SuSe 13.1this is quite a bit different. I have got as far as the network being auto and active with an Icon showing on the taskbar. However when I click on the Windows network Icon SuSe tyies to locate my Computer but then comes back with " failed to reteive share list from server. This is as far as I can get after several hours of trying.
i have installed fedora 15(lovelock) on my lenovo z560 ideapad laptop. in fedora 15 lovelock internet is not working by wire or wireless. Network controller: Broadcom Corporation BCM4322 803.11a/b/g/n Wireless LAN Controller (rev 01)
[amit@localhost ~]$ ifconfig em2 Link encap:Ethernet HWaddr 88:AE:1D:274:45 UP BROADCAST MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0
My laptop has been working fine with ubuntu 10.04, and earlier today it shut down after running out of battery. I came to use itr and discovered that the wifi icon had disappeared from the panel bar, and it won't connect to the wireless networkor via a wired connection.I have had a play around with this, tried ping -c5 google.comresult was:ping: unknown host google.comand ping -c5 22.214.171.124result: onnect:etwork is unreachable.I have other computers connecting to this network and know that it is working fine.
I just upgraded to Fedora 13 (from 10, using preupgrade), and I've gotten most things working again, but I'm still having trouble with the network.My wired connection (eth0) doesn't connect on boot (even though ONBOOT=yes in /usr/sysconfig/network-scripts/ifcfg-eth0).Because of that, I figured I'd just leave eth0 connected manually (with ifup eth0). However, I then found that if I try to connect to a VPN like this, the system reverts to the "stalling every time I try to connect to the internet" problem that I had earlier.
I just installed (dual-boot with Vista) Ubuntu 9.10 in my Toshiba Satellite M300. The problem is that (when using Ubuntu 9.10), its network is dead, both wireless and wired. The LEDs of the LAN port don't even blink. My wifi is not also detected. Both of my wifi device and LAN port are functional when using Vista.
The reason for this is I can connect to the internet on my ps3 through my laptop, and I can stream from my laptop to ps3 through wired connection. This works fine in windows 7 all I had to do was right click bridge connections. As I dual boot I don't want to have to make any changes to the settings on the ps3.
My interfaces are: eth0 - wired wlan0 - wireless
I installed bridge-utils and created a bridge and added both eth0 and wlan0 to it. However I could not get it to work. I have also tried internet sharing through network manager and firestarter.
I'm not a total newbie, but run into some strange problems with my installation of Lucid.Everything was working fine yesterday. I shut down the laptop and powered it up this morning and had problems with network. I have two NICs (wired and wireless). Both are set to pick up IP settings from DHCP and both do, however when using wired network I can't communicate with outside world - can't even ping the default gateway (but pinging 127.0.0.1 or IP address of the NIC no problem, so stack should be OK).When on the wireless network everything works fine (otherwise I would struggle to write this post ).What is very weird though is that I have a VMWare Player installed and using Windows VM on wired network works just great!
I noticed that when you're persistent it happens that you can ping but huge chunks of traffic are lost (e.g. packet 1-10 would pass, 11-40 would be lost, 41-59 would pass and so on).I restarted Ubuntu, tried shutting down interfaces, disabling networking and nothing helped. I don't recall performing any changes (at least that I would be aware of).Can anyone suggest something?BTW. This is not DNS issue as both IP addresses and FQDNs do not work. When I refer to using a given network (wired or wireless) the other one is down with ifconfig command...
I'm new to Ubuntu - I've decided to give Ubuntu Studio a go as an alternative to Windows. However, after installing it, neither of my network cards work. I have a Intel Pro Wireless 3945ABG wireless card, and a Broadcom Netlink Gigabit Wired card. Neither work, And I'm not sure how to. I've tried searching, and have come up with the .tgz file here, but I have no idea what to do with it I'm concentrating on the wireless card for the moment, seeing as that will be the main one I use.
I have installed Linux for the first time on an old Gateway purchased from work. The system seems up and running, but I can't get connected to my wireless or the wired network. I have tried using the network manager, but it isn't working. I have tried reinstalling Fedora 12 I have the following LSUSB and LSCPI output.
Actually I need the wireless adapter to connect to the AP, so both of the ethernet card should be disabled. Infact, when I try to access to the AP I must disable the eth0 card by using (sudo ifconfig eth0 down), otherwise the route assigns the default gw (192.168.1.1) to the eth0 device and the network is useless.
I'm trying to set up a wireless or wired network (wireless would be better...) to share my connection with my housemate, as well as with some devices. The only guide I found regarding this (I must admit, I didn't have much time to put into research), was dating back to 2005, and although doable, seemed somewhat confusing. Getting to the point: is there a way (maybe a standalone program, or some kind of plugin) to share a connection?
I've installed F10 on my laptop since few days and I'm facing an annoying networking issue: the network connection seems to work well when, suddently, it goes down for a while, and then come back.This happens with both wired and wireless (Intel PRO/ Wireless 3945ABG) connection.
I just got a new laptop...Dell Vostro 3500. Took off Win put on Ubuntu...all went fine. I did all updates and app downloads using my WIRED NETWORK as wireless wasnt working. However I was more interested in setting up the new computer. Anyway so after all is installed up pops "Broadcom STA Wireless driver" Proprietary driver do you want to install. Obviously I said yes...
Well now My wireless is working great but for some reason my Wired (auto eth0) no longer works. It just says disconnected and its grayed in. I'm pretty much a newbie but did try a few things like:
apt-get update apt-get "something" essential (thats not a command just from memory it was something like that)
However I've had no luck. This Broadcom driver seems to have knocked out my wired network.
I just installed Lucid Lynx on my Dell Vostro 1000 laptop. The problem I'm having is that my wired network card has died on me prior to installation. I'm having the hardest time finding the required files to make my Broadcom BCM4311 wireless card work without being able to download any packages from the web. If anyone knows which files I need and which order I should use to install them that would be great.
I have a wireless network (192.168.1.0) that's bridged to the Internet and a wired one (192.168.0.0) that's only local. When I am connected to both networks, Natty wants to route my Internet traffic through the wired, local-only one.
Can I make it automatically "just work", so that the right network is chosen for Internet traffic? Otherwise, what's the workaround?
I have a Mandriva linux box connected by cable to my router. When I stream audio using this box it crashes all the wireless computers on my network. There is no effect on wired computers. All but the one computer are windows (xp or vista). The affected wireless computers are not able to even find my wireless network. I have to reboot the router to get them online.
The problem with my wireless network. I have Dell DV6 Pavilion 2115 eg laptop and i installed Ubuntu 11.4 and internet and wireless worked, until i reboted my system it has disapear. I cant no longer to connect to a wireless network. It dont shows me any wireless network. My wireless card is Atheros AR 9285 802.11b/g/n Wifi Adapter
I am having a little trouble connecting to my wireless network. Running Fedora 10 32 bit.I'm trying to connect to a hidden wireless network. I updated the firmware for my driver but apparantly the driver is still not working. Broadcom has a driver from their website for Linux 32 bit systems. Should I attempt to install it? I read a post where the driver is built into the system kernel. If so I would need to blacklist the one of the drivers. Correct?
[justin@justin ~]$ iwlist scan lo Interface doesn't support scanning. eth0 Interface doesn't support scanning. wmaster0 Interface doesn't support scanning. code....
I have searched and found no answer to this one. I have a Linksys DSL router BEFSR41 (wired) which works great. I recently got a Linksys Wireless-G Broadband router. Which also works great with my Dell mini 10 netbook running 10.04. I have two computers (wired) also running 10.04, what I want to do is use both routers with only one internet DSL connection. I have the wired (Master Router) connected to the wireless (Slave Router) and I fire up the Dell it sees it and connects but I can't connect to the internet. I can connect through my network and share files through all 3 machines. Do I need to reset the wireless, to enjoy the internet? If so the wireless came without instructions or CD.
I have a new install of Ubuntu 10.04.2 and the network will not connect. This is a dual boot desktop system with Vista. The Vista network is good. When I boot up Ubuntu, the network icon seems to be searching but then the message "Wired network disconnected - you are now offline" appears. I ran ifconfig -a & got:
eth0 Link encap:Ethernet HWaddr 00:1d:09:7b:b5:29 inet6 addr: fe80::21d:9ff:fe7b:b529/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1