Ubuntu Networking :: Unable To Connect To Wireless But Can Connect To Wired
Nov 2, 2010I am unable to connect to wireless network in ubuntu 10.10.i have noticed that the iwlagn driver isnt been used by anything.
View 9 RepliesI am unable to connect to wireless network in ubuntu 10.10.i have noticed that the iwlagn driver isnt been used by anything.
View 9 RepliesI am unable to connect to any network, wired or wireless. Network-manager and wicd are both gone, as in no longer installed. Please don't tell me to apt-get anything. I have no network connection. I have tried downloading packages for nm onto a usb stick only to find myself in dependency hell which ended with the impassible error "Requires installation of untrusted packages".
View 6 Replies View Relatedi have installed fedora 15(lovelock) on my lenovo z560 ideapad laptop. in fedora 15 lovelock internet is not working by wire or wireless. Network controller: Broadcom Corporation BCM4322 803.11a/b/g/n Wireless LAN Controller (rev 01)
[amit@localhost ~]$ ifconfig
em2 Link encap:Ethernet HWaddr 88:AE:1D:274:45
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
[code].....
I'm trying to install Ubuntu 10.04 on my Toshiba A200-12U laptop (with an Atheros AR5007EG wireless card), but networking is being problematic.I entered Network Configurations and tried to get 'Auto eth0' working -- I went to Edit > IPv4 settings and filled in 'Addresses' with the details of my connection:
Address: 192.168.1.254 (the local IP of my router)
Netmask: 255.255.252.0
Gateway: 94.195.208.1
[code]....
in linux world and have recently downloaded and installed ubuntu desktop 10.10i cannot connect to both wired and wireless ethernet on my laptopit tries to connect but fails in 30 seconds , it says"disconnected" while i am able to connect to the same in windows i have broadcom 4315 and i have tried both fwcutter and ndiswrapper but the problem persiststhe device id is 14e4:4315
View 9 Replies View RelatedI've just installed 11.04 Natty on an old Laptop (Dell Lattitude C400) and am unable to connect to my home network (wired LAN connection, no wireless). The laptop previously had WinXP installed and was able to connect (I have also double checked the cables and ports and they're all functioning ok).
sudo lshw -C network
Code:
*-network
description: Ethernet interface
product: 3c905C-TX/TX-M [Tornado]
vendor: 3Com Corporation
[code]...
I just did a fresh install of ubuntu studio 10.04 and I can not connect to either a wired or wireless network. The In Network Tools the IPv4 IP address is 127.0.0.1. It is plugged into a network giving out DHCP IP's. Both wired and wireless were working on ubuntu 9. I have tried to bring eth0 up in the terminal but it did not give an error or anything. It it running on a Dell Latitude D820 laptop.
View 3 Replies View RelatedI have recently developed a problem with my computer connecting to the internet which has totally stumped me and is currently forcing my to use windows much to my frustration. I am using ubuntu 10.04 on a Toshiba Satellite laptop. My wireless and wired network connections will not connect. They are all present in the menu and i can click on them but the connection tries to connect and then just times out and fails to connect. Everything still works fine in windows Vista. The more confusing thing is i tried some live disks to see if they would work but they all did exactly the same thing including a live disk of ubuntu 9.10 which used to work perfectly and live disks of openSUSE 11.4 and Mint 10. I struggling to tell if this could be a hardware problem or not. The fact that the live disks wouldn't work suggests a hardware problem but the fact that Vista still works totally throws that argument. I have looked all over these forums and elsewhere and have found some similar ish problems but non seem to have the severity of this one as all of those seem to be wireless only problems. The only thing that i was doing at the time this started was i had just set up a new secondary user account but i suspect that may be coincidental.
View 4 Replies View RelatedI installed ubuntu 9.10 on my laptop a few days ago and love the OS so far. However, initially i could only get internet connection though an ethernet cord. After much internet searching, i finally figured out how to get wireless internet. Unfortunately, in setting up wireless internet, I no longer have wired internet. The system doesn't seem to recognize my wired internet anymore. I'd like a scenario where i can connect to the internet both wired and wireless.
View 9 Replies View RelatedI have just installed Ubuntu 10.04 on an HP Pavilion dv6000 series laptop, dual-boot. Everything is working except the networking. It can see wireless networks, and when I type in the password for my wireless network, it tries to connect, then asks for the password again. When I plug in the Ethernet cable, again it tries to connect, but after a few seconds gives up and tells me I am now offline.
View 8 Replies View RelatedI'm running Ubuntu 11.4 on my laptop, and I can't connect to the internet with it (neither wired nor wireless). It used to be all fine under 10.10.
View 1 Replies View RelatedF14 did not recognize my wired or wireless NIC upon installation. I have enabled network manager, what should I do from here? Here is my hardware specifications:
Network controller: Realtek Semiconductor Co., Ltd. Device 8176 (rev 01)
Ethernet controller: JMicron Technology Corp. JMC250 PCI Express Gigabit Ethernet Controller (rev 05)
I recently installed Ubuntu 9.10 on my Dell Inspiron 1545 64-bit laptop. Before that I used Windows7. In Windows, the internet connection worked perfectly well. But after installing Ubuntu, I am unable to connect to the internet. The network-manager applet finally says that "You are disconnected". When I do the "ifconfig", I got no IP address.
So, I installed Ubuntu 9.04 in the same system. But the problem persists.
I gone through many posts in this forum but nothing was useful.
how to make dsl setup and to acess both wireless and wired at a time.
View 2 Replies View RelatedI am a beginner to ubuntu. I have installed ubuntu 10.04 on my laptop using wubi.When I am trying to edit the IP address using network editor,apply button is not highlighted.I managed to give IP as well as netmask through command prompt.But I am not able to give gateway and dns IP.Please help me configuring this.
View 1 Replies View RelatedI have just installed ubuntu 10.04 using the wubi installer to dual-boot my machine. Under ubuntu, I am not able to connect to the internet or my router. Everything works fine under windows. I have tried to find relevant information in the forums, but nothing seems to work for me. I have tried disabling ipv6, setting a static ip, but no go. ifconfig shows no IP, dhclient results in no DHCP offers and pinging my router's IP results in Network is Unreachable.
View 9 Replies View RelatedMy laptop has been working fine with ubuntu 10.04, and earlier today it shut down after running out of battery. I came to use itr and discovered that the wifi icon had disappeared from the panel bar, and it won't connect to the wireless networkor via a wired connection.I have had a play around with this, tried ping -c5 google.comresult was:ping: unknown host google.comand ping -c5 4.2.2.1result: onnect:etwork is unreachable.I have other computers connecting to this network and know that it is working fine.
View 8 Replies View RelatedI just switched from Ubuntu to Fedora 13 because I was unable to get Ubuntu to connect to wireless networks. I tried everything suggested in help and forums, and kept getting "Bad Password" with WICD and Network Manager. Now, with Fedora...I still can't connect.
Problem #1: The guide says to "...make sure that the relevant wireless interface (usually eth0 or eth1) is controlled by NetworkManager," and that I do this via: System>Administration>Network
However, there is no Network option under System>Administration.
Problem #2: I open Network Manager, which displays a list of networks. I click on mine, configure it with WPA and the right password, and it fails to connect: "The network connection has been disconnected."
I have searched and found no answer to this one. I have a Linksys DSL router BEFSR41 (wired) which works great. I recently got a Linksys Wireless-G Broadband router. Which also works great with my Dell mini 10 netbook running 10.04. I have two computers (wired) also running 10.04, what I want to do is use both routers with only one internet DSL connection. I have the wired (Master Router) connected to the wireless (Slave Router) and I fire up the Dell it sees it and connects but I can't connect to the internet. I can connect through my network and share files through all 3 machines. Do I need to reset the wireless, to enjoy the internet? If so the wireless came without instructions or CD.
View 1 Replies View RelatedI have a laptop with Ubuntu 9.04 on it. I wanted to try out fluxbox, so I did a apt-get install fluxbox. When I went into fluxbox, I was having trouble getting connected to my network wirelessly. I saw a post online that said to install wicd. So I did a apt-get install wicd. This removed the Gnome network manager (nm-applet) which I didn't realize that it would do. I removed wicd when I saw this is what happened, and now I can't connect to a wired or wireless network. I tried connecting to my wired network, and I ran
Code:
sudo ifconfig eth0 192.168.1.115
but I still can't access the internet, or other things on the network.
I just dual-booted my Acer Aspire 3810TZ laptop with Ubuntu 10.04. When I first tried to connect to my home wireless network, it connected fine. However, now whenever I start the laptop, it will not connect. The network appears in the available networks list, but it fails to connect. I know the network is ok, because I can still connect to it fine from Windows.
My network adapter is Intel Wifi 1000 BGN. Apparently (from [URL]) the drivers for this card should be part of the distribution.
I can't understand why it connected once, but (without any changes to the system at all) it won't work now.
I'm a first time Ubuntu user and I just installled it more out of curiosity than anything else so I don't know jack abiut linux just that people say it's better.
Anyway I have a Dell Inspiron 1526 laptop and I'm unable to connect to the wireless network. The router that we use is an Apple Airport Express device to connect.
I checked using the troubleshooting guide and this is what I got in the Terminal:
moofknock@moofknock-laptop:~$ sudo lshw -C network
[sudo] password for moofknock:
*-network
description: Network controller
[Code]....
Just installed Fedora 14 from the Live CD i686 on my Dell Inspiron 1521. I can't connect to the SpeedTouch 585 on either wireless broadcom card or the wired Ethernet card.
I can connect to it from the same Laptop on the Vista which is on dual boot on the same laptop.
Further confusing is that I ran Fedora 14 and connected to another SpeedTouch today.
Already checked the Channel on the wireless nic and it's on the same one as the SpeedTouch.
I rebooted my machine, and now I can't connect to the wired network for some reason. Wireless works fine.
Code:
eth0 Link encap:Ethernet HWaddr 00:18:f3:5a:66:70
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
[Code]....
I am unable to connect to my wireless connection! i have put in all the correct details and password but the connect button is greyed out so I am unable to click on it.
View 1 Replies View RelatedI am using Belkin router and i connect with MAC ID only. When i connect with my Vista it works properly but when i reboot and try to connect with Ubuntu it's not connecting.
I looked for my Ubuntu mac id and i added that also but no use. It says it's connected and when i try to google it, the page not found
This is baffling me but I am easily baffled/baffeld? I carefully followed these instructions to install a a working driver http://ubuntuforums.org/showthread.php?t=760568. It all went fine, my wireless light came on and it detected my wireless network. I know my WPA2 code (I can connect on the same computer in windows 7) and my keyring code. but I still can't connect it whirs away for quite a while before giving up and saying not connected.[Code]....
View 5 Replies View RelatedI have had a router die on me and have bought another (maybe a bad buy!) The new router is Linksys WAG120n. Ethernet is fine. Laptop wireless adapter is Atheros AR5009 802 11a/g/n. I have setup a wireless connection but it is not connecting to it. I have checked the router settings and these seem to be OK! I'll try to give any details required.
View 2 Replies View RelatedI am unable to connect to internet using my wifi network. Though I can share folders on network. Here are the details:
HP Pavalion laptop - DV6149us
lspci
00:00.0 Host bridge: Intel Corporation Mobile 945GM/PM/GMS, 943/940GML and 945GT Express Memory Controller Hub (rev 03)
00:02.0 VGA compatible controller: Intel Corporation Mobile 945GM/GMS, 943/940GML Express Integrated Graphics Controller (rev 03)
[Code]....
Sometimes I meet problems conntecting my netbook with the wireless. It just tries too long to connect and even refuses my own network. Where to seek the problem? There is no error message...
View 3 Replies View Related