When I try to connect to any Wireless Networks in Fedora, the option at the top of the screen is grayed out. I can only connect to VPN, a hidden network, or create a new wireless network. My wireless works fine on the Vista side, so I am a bit confused at this
View 5 RepliesI just switched from Ubuntu to Fedora 13 because I was unable to get Ubuntu to connect to wireless networks. I tried everything suggested in help and forums, and kept getting "Bad Password" with WICD and Network Manager. Now, with Fedora...I still can't connect.
Problem #1: The guide says to "...make sure that the relevant wireless interface (usually eth0 or eth1) is controlled by NetworkManager," and that I do this via: System>Administration>Network
However, there is no Network option under System>Administration.
Problem #2: I open Network Manager, which displays a list of networks. I click on mine, configure it with WPA and the right password, and it fails to connect: "The network connection has been disconnected."
Am new, as of today to Fedora. I am unable to connect to my home wireless network. I have checked the security settings WPA PSK Personal TKIS, on the router. I have two windows PCs that are connected in this way.
The error message in Fedora 15 Network is Authentication required by wireless network. The details I have entered are correct, but no joy. Again, I am entirely new to Fedora
i have installed fedora 15(lovelock) on my lenovo z560 ideapad laptop. in fedora 15 lovelock internet is not working by wire or wireless. Network controller: Broadcom Corporation BCM4322 803.11a/b/g/n Wireless LAN Controller (rev 01)
[amit@localhost ~]$ ifconfig
em2 Link encap:Ethernet HWaddr 88:AE:1D:274:45
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
[code].....
I am unable to connect to wireless network in ubuntu 10.10.i have noticed that the iwlagn driver isnt been used by anything.
View 9 Replies View RelatedI just dual-booted my Acer Aspire 3810TZ laptop with Ubuntu 10.04. When I first tried to connect to my home wireless network, it connected fine. However, now whenever I start the laptop, it will not connect. The network appears in the available networks list, but it fails to connect. I know the network is ok, because I can still connect to it fine from Windows.
My network adapter is Intel Wifi 1000 BGN. Apparently (from [URL]) the drivers for this card should be part of the distribution.
I can't understand why it connected once, but (without any changes to the system at all) it won't work now.
I'm a first time Ubuntu user and I just installled it more out of curiosity than anything else so I don't know jack abiut linux just that people say it's better.
Anyway I have a Dell Inspiron 1526 laptop and I'm unable to connect to the wireless network. The router that we use is an Apple Airport Express device to connect.
I checked using the troubleshooting guide and this is what I got in the Terminal:
moofknock@moofknock-laptop:~$ sudo lshw -C network
[sudo] password for moofknock:
*-network
description: Network controller
[Code]....
I am unable to connect to my wireless connection! i have put in all the correct details and password but the connect button is greyed out so I am unable to click on it.
View 1 Replies View RelatedI am using Belkin router and i connect with MAC ID only. When i connect with my Vista it works properly but when i reboot and try to connect with Ubuntu it's not connecting.
I looked for my Ubuntu mac id and i added that also but no use. It says it's connected and when i try to google it, the page not found
This is baffling me but I am easily baffled/baffeld? I carefully followed these instructions to install a a working driver http://ubuntuforums.org/showthread.php?t=760568. It all went fine, my wireless light came on and it detected my wireless network. I know my WPA2 code (I can connect on the same computer in windows 7) and my keyring code. but I still can't connect it whirs away for quite a while before giving up and saying not connected.[Code]....
View 5 Replies View RelatedI have had a router die on me and have bought another (maybe a bad buy!) The new router is Linksys WAG120n. Ethernet is fine. Laptop wireless adapter is Atheros AR5009 802 11a/g/n. I have setup a wireless connection but it is not connecting to it. I have checked the router settings and these seem to be OK! I'll try to give any details required.
View 2 Replies View RelatedI am unable to connect to internet using my wifi network. Though I can share folders on network. Here are the details:
HP Pavalion laptop - DV6149us
lspci
00:00.0 Host bridge: Intel Corporation Mobile 945GM/PM/GMS, 943/940GML and 945GT Express Memory Controller Hub (rev 03)
00:02.0 VGA compatible controller: Intel Corporation Mobile 945GM/GMS, 943/940GML Express Integrated Graphics Controller (rev 03)
[Code]....
Sometimes I meet problems conntecting my netbook with the wireless. It just tries too long to connect and even refuses my own network. Where to seek the problem? There is no error message...
View 3 Replies View RelatedI ve just install ubuntu 10.10 and am unable to connect to wireless connect. I was able to connect on the try ubuntu before install option. I have dual booted Windows 7 and Ubuntu 10.10. I have tried connecting without the WEP key and still no luck. Just found it strange that connect on try it but not after full install.
View 4 Replies View RelatedAt the very begging of my ubuntu experience (2 days ago) I was able to check the "Enable Wireless" bar up in the top right corner, but I was unable to connect any wireless networks, cause none would show on the list.
Using nm-tool i get this info:
[Code]...
I installed Ubuntu 11.04 and am unable to connect to wireless internet. I looked under additional drivers and there doesn't seem to be anything listed there.
View 3 Replies View RelatedI installed 11.04 ubuntu 2 days ago. I have had thousands issues trying to connect to my wireless network router dlink di524. My wireless card is a dlink dwl g122 ver c1. I can't connect to the network no matter what configuration I try.
- first time i tried to connect i had static ip settled on my router so I tried to configure Network manager from GUI. I couldn't connect; it kept trying to connect forever. so I completely removed from terminal NM (using guides on internet) e installed wicd: same problem. Tried to configure manually network/interfaces file. Didn't work. Reset router and set dhcp . Tried everything again first with NM and then wicd. Didn't solve. Reinstalled ubuntu, fearing I messed up with some configuration files and reset again router. No solution
Tried pinguy os, zorin e linux mint . Nope Borrowed a network card from a friend after reading dlink dwl g122 could have some issues with linux. Tried this realtek card : same problems as above. Finally I tried again after the fifth reinstallation of ubuntu. Both NM and wicd keep saying wrong password. Changed different password. Password is fine of course (i'm using it now with win) So I Reset router password to none. Now it says: "acquiring ip address" and keep saying that forever. So i tried the last attempt: I tried to connect from zorin5 live to the same wifi network.. Ok so I happily reinstalled everything again (zorin5). first access after installation: same problems as above
Now I'm using win7 on the same wifi network, router, and same card (cards) and everything works fine at first attempt.
What has changed to the wireless function and possibly the use of the ndiswrapper in 11.04.
I originally install ubuntu 9.10 and immediately upgraded to 10.04. I have just now decided to upgrade to 10.10 and then to 11.04. Everything went ok and all still worked fine up until the upgrade to 11.04.
I've checked my settings and they are fine. The power light is still on my wireless card but no connection?
Firstly, the actual problem I'm having is that when I start my computer (netbook) up in the morning and try to connect to the router (wirelessly) it just... doesn't work. I've used it before, at full signal strength, and it was completely fine. It never disconnects me or anything - but if I shut down my computer, like I do overnight, when I start it up again often it's hardly getting a signal at all (or so it says) and when it tries to connect it makes the connecting animation and occasionally flashes to a circular thing like firefox's loading animation. Eventually it just fails.
I try restarting my computer, but it doesn't seem to help. The last time, I had to wait until the signal looked "full" again, then delete the settings in "edit connections" for that router and only then would it let me log in again, even though I was using the same password from the same computer (even in the same place). That only seems to help when the connection looks "full" though, and even then, not always. Normally I'd try resetting the router, but I can't because it's locked in the next room (I rent a room here and the guy with the key is rarely around) but honestly I don't think the router is causing this, for a few reasons:............
I am unable to connect to my wireless network. When I click on Network manager it says under wireless "device not managed".
View 9 Replies View RelatedI have a Dell Inspiron 1525. I am unable to connect to wireless networks. I have a fresh installation of Ubuntu 8.04. I have installed Ndiswrapper (ndiswrapper-utils_1.8-0ubuntu2_i386.deb) and the GUI for ndiswrapper. The ndiwrapper GUI reports that the hardware was not found. Yet I am able to connect to the wlan using Windows.
View 3 Replies View RelatedI have Windows XP with a gigaset adapter which connects to wirelessly to a Belkin router. I'm with Virgin Media.
I installed Wubi Ubuntu to try it out, and it all worked perfectly accept no wireless networks, not even nextdoors were listed.
It's enabled but it says it's disconnected. I have no idea what to do.
Is it recognizing my adapter?
I am unable to connect to any network, wired or wireless. Network-manager and wicd are both gone, as in no longer installed. Please don't tell me to apt-get anything. I have no network connection. I have tried downloading packages for nm onto a usb stick only to find myself in dependency hell which ended with the impassible error "Requires installation of untrusted packages".
View 6 Replies View RelatedRunning Ubuntu 10.04 Unable to get Ubuntu to find the ASUS USB Wireless to connect for network. I got the Broadcom to work using ndiswrapper but the range on it is unbearable meaning I have to be in the same room as the router. Hoping this has a much better range.
[Code]...
Currently I'm having trouble connecting to the guest wireless network at my work. I've read through a couple threads that seem similar to my problem. I tried going through the terminal window and following the instructions that was offered to others. I'm just wondering if my hardware is different, if I need drivers, if my permissions aren't correct.
1. I recently received a Sony Vaio laptop model # VGN-FE770G from a friend, and I'm enjoying running Ubuntu.
2. I followed another thread that suggested to change some lines in /etc/network/interfaces, but I don't have permission to edit this file. I don't really have the need to set up multiple users on my laptop, so how can I change my permissions to root? (Or is it a good idea even?) Should I log in as root?
3. How can I set my laptop up to be flexible with network selections, using hardware: (built-in camera and microphone for example), and useful applications?
I ran "ifconfig -a" and this is what I got.
Quote:
eth0 Link encap:Ethernet HWaddr 00:13:a9:48:c3:00
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
[Code]....
New Ubuntu user here, and I'm having difficulties connecting to my router at home. I've searched around the forum for a couple of hours now, to no avail. My router was originally not broadcasting ssid, so I turned broadcasting on. Now I can see the router, but when I enter a password (which I know is correct) nothing gets connected.
View 9 Replies View RelatedI'm trying to install Ubuntu 10.04 on my Toshiba A200-12U laptop (with an Atheros AR5007EG wireless card), but networking is being problematic.I entered Network Configurations and tried to get 'Auto eth0' working -- I went to Edit > IPv4 settings and filled in 'Addresses' with the details of my connection:
Address: 192.168.1.254 (the local IP of my router)
Netmask: 255.255.252.0
Gateway: 94.195.208.1
[code]....
I'm running ubuntu 9.10 on my desktop.Wireless networks appear on the dropdown menu but when I try to connect to my home network the authentication box appears, after typing my password the box disappears and it continues to connect but nothing happens and after a while the authentication box appears again. So.. no internetz connected.
View 7 Replies View RelatedI am not able to find the most Wireles icon, I want to connect to other networks, so there will not I print a summarizing what is happening.
View 3 Replies View RelatedI am having a little trouble connecting to my wireless network. Running Fedora 10 32 bit.I'm trying to connect to a hidden wireless network. I updated the firmware for my driver but apparantly the driver is still not working. Broadcom has a driver from their website for Linux 32 bit systems. Should I attempt to install it? I read a post where the driver is built into the system kernel. If so I would need to blacklist the one of the drivers. Correct?
[justin@justin ~]$ iwlist scan
lo Interface doesn't support scanning.
eth0 Interface doesn't support scanning.
wmaster0 Interface doesn't support scanning.
code....