Can I use my wired desktop connection to my wireless router to allow me to connect to an external wireless signal?
DESKTOP <--(wired)--> Wrouter <--(wireless)--> wireless.
I have Ubuntu 9.10 a dell laptop i am using a tew-644ub usb wireless adaptar and it's seeing signals but wont connect to any my network is unsecured and open. everytime i try it does this swirlly thing then says diconected. im using a diferent computer to post this so if there
View 6 Replies View RelatedI have a new Acer Aspire One, model D250-1958. It uses the Atheros AR928X. I've tried Ubuntu Netbook Remix 9.10 and Ubuntu Netbook Edition 10.04, as well as the conventional Ubuntu. Everything works beautifully, except no wireless. The netbook picks up the signal, but when I provide the Key it fails to connect, and eventually prompts me for the key again.
I've tried to research this on my own, but haven't found a solution. In particular, the solution reported by narnie for his Acer Aspire One D250-1584, <HERE>, didn't work for me.
I'd really like to get this working. The netbook will be much less useful if it can't make use of our wireless router.
I'm running ubuntu 10.10, in a Gateway M-6750. I can't get my wireless to work properly.
After I lose my wireless signal, I can't connect to a network again. I have to restart my computer or, remove the ndiswrapper module and insert it again so that I can connect to the network again.
I do this with:
Also, there are sometimes when the computer freezes up when trying to search for a signal.
My box: Dell Inspiron 1545. lspci results below. I have enabled the Broadcom STA restricted driver.Problems:1. I am noticing in Ubuntu (using Network Manager and Wicd) that I am unable to connect to wireless signals tha are very weak. In my other OS (dual boot), I am able to connect to these weak signals.2. And the speed of these networks is much slower, and the disconnect rate is much higher than in my other OSI am THRILLED with Ubuntu otherwise, just looking to fix this issue so I can use Ubuntu as my primary OS.Could this be an Broadcom STA issue, or Software config issue? etc? Obviously not hardware cause hardware is same on other OS.
Code:
~$ lspci
00:00.0 Host bridge: Intel Corporation Mobile 4 Series Chipset Memory Controller Hub (rev
[code]...
I installed WICD because I was looking around the internet and the Ubuntu forums said that it was the best fix for the Network Manager not working. I added the source and installed the package like the Ubuntu site said. I go to Applications => Internet => Wicd Network Manager. It says no wireless networks found. I know that the router is working because my sister is right here next to me playing Maplestory on her laptop! When I do the lshw -C network function in the terminal it is only bringing up two things: the network controller and the ethernet controller. I used Yahoo Answers as my first goto and the answers there said that Linux doesn't have the drivers for the router. I have a Netgear Wireless-N 300 Router WNR2000 and a Dell Inspiron 1750, if that helps. Can someone give me a link to the drivers or tell me in detail what to do?
View 4 Replies View RelatedMy mother has Windows Vista and i have linux ubuntu. She has a special verizon card that she inserts into her laptop for internet. My computer also has an internal wireless card, but the signal here is very poor. Supposedly, among windows computers, I would be able to get a flashdrive, and with a little program uploaded from my moms computer, set things up using the flashdrive on my computer to share the internet that she pays good money for =/ However, it wont work with ubuntu, which isnt in the windows inner circle. When I open the executable file with WINE it says that it cant run wireless network setup "on this version of windows". lawl. I was wondering, is there any way around that? Is there anyway to network with my mothers internet?
View 2 Replies View RelatedFor the past few months I've been using Ultimate Edition 2.3 on my laptop. Various problems I encountered convinced me to switch. I installed Ubuntu 9.10 today and after the install I can't pick up my wireless router on the list of available networks. I'm able to pick up every other one on my block, just not my own. My server and my roommates laptop can pick it up and are connected to it, the problem seems to be exclusive to this laptop with the fresh install on it.I tried the 'connect to hidden network' option and it doesn't connect, it just keeps asking for the psk
View 5 Replies View RelatedFor some reason my laptop cannot keep a connection with any wireless signal. I have tried several networks and resetting the router and it just doesnt work. Im not sure why...i have selected to connect to a certain network and it either takes forever to finally connect or doesnt connect at all. also when it does connect it only last a few minutes, meanwhile using win7 i have no issues with the connection.
View 2 Replies View RelatedI just installed the latest version of Linux on my Dell Mini 910 and it's now not picking up my wireless signal. The wireless card is enabled so I'm not sure what's going on. Btw, I tried entering the smb command that was given to the other member about 4 threads down as he had the same issue. Didn't work though.
View 9 Replies View RelatedMy laptop has sat in the same area for days, I've noticed that in Ubuntu I get a real low signal and can barely connect for a minute and on Windows I get like 3/5 bars. I don't understand what's going on. Is it a driver issue or something?My wireless card is Realtek RTL8187B and using the latest Ubuntu as of today.But just so everyone knows, I have google'd and search around for a few hours. I've seen many different types of problems that just wasn't like mine. Lots of people can't even get theirs to work and some people use different types of drivers. But Ubuntu detects my wireless card fine, I'm just having a signal strength problem. Because the Windows on my laptop has a much stronger signal as stated above.
View 2 Replies View RelatedAfter I upgraded from 8.10 (or 8.4, I'm not sure), the wireless signal is very weak:
Code:
~$ sudo iwconfig wlan0
wlan0 IEEE 802.11bg ESSID:"mina"
[code]....
Im looking for a device that connects via usb in order to greatly increase the range of my wireless adapter card. It must support g and n channels. Ideally if the device need no config, that is if its 'plug in and play' would be ideal. Though if theres support in the ubuntu drivers tool that would be ok too. Im based in europe as well so it has to work here too.
Also looking to find a wireless adapter that supports packet injection on ubuntu-again with a device that needs no drivers or has drivers in the repos.for the record im looking to use these for penetration testing of a network i own.
I just installed Fedora 12 on my EEE PC has weaker wireless signal that I have previously had with any other linux distro or windows.Has anyone else had this problem, and is there anyway to increase to wireless signal?
View 3 Replies View RelatedIs there a way to keep a wireless AP from generating an RF signal at all until it gets pinged by a client which:
1) Knows it's (the AP's) IP, name, passcode, and operating port,
2) Knows which frequency, and periodic ping-rate to use,
3) And, identifies itself not only appropriately, and timely, but only pings twice before it falls silent, awaiting a response, all others would over run the limit, and thusly fail the AP screening and the AP would totally ignore them, logs the attempts, and stays cold, dark, and silent.
In short, only one (1) device is capable of turning it on.
Seems to me that conceptually, it's quite do-able. Has it been done?
I recently moved to Beijing and am having trouble with my apartment's wireless setup. My laptop can connect to any wireless network I find out in Beijing but not our home network. My Roommate has a mac laptop and has no issues connecting to our wireless router. It appears to connect but receive no signal, which is frustrating me to no end. Here is my spec list and the model of wireless router we are using.
[Code]...
my laptop can't find the wireless signal of my university's wifi. My room is a bit far, so I wonder if there are solutions for this.
View 1 Replies View Relatedthis isnt happening on ubuntu but I think this is more or less a kernel problem that could happen with any flavor. After a new install off of a live cd my wireless card is not picking up any signals...i was able to use wireless while using the live cd but now after it has been isntalled to the hard drive it is not working. even tried in terminal to manually look (iwlist wlan0 scan) but it isnt picking up the signal
View 2 Replies View RelatedI am among those unfortunate wretches with an Atheros wireless card (ar5001) and I've had problems with it from the day I installed Ubuntu. I've been using Madwifi to connect to the internet, and it's worked fine, until I lately changed my internet connection, got a new modem etc.
Madwifi works still, but the signal is really weak - while not so on Windows Vista.
I know it's NOT ipv6 related. Do I have to change the connection settings? Is my card outdated or whatever? Am I using inefficient drivers? Should I just not use Madwifi and rather something else instead?
(Trying to install ndiswrapper and get it to work was a dreadful process, so I won't attempt that again.)
Situation is a cable modem and a Belkin F5D8235 Wireless-N router (and a computer) are at one end of the property. Approx 150-200 ft away I want to put 3 desktop computers none of which have a wireless card or device. I DO have a Linksys WRT54G I'm not using.I want to hardwire the 3 desktop computers to a switch that is hard wired to the Linksys. Putting a wireless card in one of the 3 computers is not practical because of physical obstructions (a lot of cabinetry, furniture, walls) that the Linksys (which can be at the window) would not have to deal with.
Is it possible for the Linksys to 'receive' the wireless signal from the Belkin so the 3 desktops can share the internet? If not, what could I put in the window to 'receive' or 'repeat' the wireless signal?I know this isn't exactly a Ubuntu question, except that 2 of the 3 computers are 64bit Lucid.
I used to be able to get onto internet with wireless connection on my HP. Now the wireless connection seems fair but I can not connect to internet.
View 14 Replies View RelatedMy wireless (Toshiba laptop, 10.04 64 bit) is just hanging when trying to connect. It was working fine but now nothing. My Wireless antennae is on and my other laptop can connect with no problems. I have restarted the router and the laptop twice.
View 1 Replies View RelatedI am unable to connect to wireless network in ubuntu 10.10.i have noticed that the iwlagn driver isnt been used by anything.
View 9 Replies View Relatedin linux world and have recently downloaded and installed ubuntu desktop 10.10i cannot connect to both wired and wireless ethernet on my laptopit tries to connect but fails in 30 seconds , it says"disconnected" while i am able to connect to the same in windows i have broadcom 4315 and i have tried both fwcutter and ndiswrapper but the problem persiststhe device id is 14e4:4315
View 9 Replies View RelatedWe use Openvpn for remote access to the office network. It would be nice to keep this running and automatically connect to the office at all times.Once started, it does this anyway. The problem lies when the user comes into the office. Openvpn connects as usual to the vpn gateway, but this causes weird routing loops.Is there a way to say to Openvpn "Always connect to the gateway unless you are on network 10.10.10.0/24" ?
View 2 Replies View RelatedI have recently installed ubuntu 11.04 on my asus eeepc1005hab. And I've had problems with the wifi. I can connect via ethernet, but the wireless won't connect. I can see the connection, but my wifi never connects. I've tried many things but it still won't work.
View 9 Replies View Relatedwlan0 Authentication capabilities :
WPA
WPA2
CIPHER-TKIP
CIPHER-CCMP
Those are my authentication capabilities, obviously. I am using a WEP encryption for my wireless router and according to this, it will not allow me to connect. Is there anyway to allow that? The wireless card works just fine in Windows, even on the same network encryption type. Using a Intel Wireless/Pro 4965 ag. Note* this is my mother's router and whatnot. She won't change it the encryption type.
The problem with my wireless network. I have Dell DV6 Pavilion 2115 eg laptop and i installed Ubuntu 11.4 and internet and wireless worked, until i reboted my system it has disapear. I cant no longer to connect to a wireless network. It dont shows me any wireless network. My wireless card is Atheros AR 9285 802.11b/g/n Wifi Adapter
View 9 Replies View RelatedI installed a Tenda W322P wireless card in my dual-boot PC running both Windows XP and Ubuntu 11.04. The card worked straight out of the box on XP, but does not function correctly under Ubuntu. My apologies for any missing/irrelevant information, I am having to post this from the Windows boot so the Ubuntu settings are not directly available at the same time as internet access.I followed the process detailed here htURL...to install and configure the driver (I believe from reading other sites that this card is the Ralink RT3062 chipset), blacklisted the original RT2860 driver that was in use (couldn't even get the card to scan for wireless networks with the default driver) and restarted the interface.
Since then, sudo iwlist scan can find my wireless router but when I attempt to connect to it, it seems to enter a loop of requesting the WEP key then pausing for a while before re-requesting the key. I know I have the key value correct because it is copied and pasted from the same text file I used to copy and paste into the passkey field on the Windows boot. Attempting to connect to the router using Ubuntu also has the rather unfortunate side-effect of crashing the wireless router, killing off all other device connections until the router has been reset.
I am running Jaunty 9.0.4. I have go through a proxy to get out to the net. It was working. Sometime yesterday it was unable to resolve the proxy server. Can't even ping it. Other computers can. I even switch cables to no avail. What could block the proxy server? I can't even ping google.com Was it something I installed through add/remove software? Has anyone seen something like this before and even better has a solution or can offer a way to troubleshoot this? I can ping myself and the default gateway server.
View 1 Replies View Related