I got a Huawei E 173 mobile internet USB. But i cannot get it to work under linux, only under windows(it has a windows installer on it, in order to work).
View 2 RepliesI have just installed ubuntu 10.10 sucessfully, but it doesn't recognize my mobile huawei alisa internet dongle.
View 1 Replies View RelatedI have a little bit of a prediciment with my Mobile Broadband dongle, even though I know I'm in a 3G area (Dongle Supports 3G connection) my internet still loads at the normal GPRS speeds max of 5kb/s. Is there anyway to change the speed of it or do I have to keep with GPRS at the moment?
View 2 Replies View RelatedI have opensuse 11.1 Gnome on Lenovo S10e. I'm wanting to establish a mobile internet connection. I have tried so far...*UMTSMON but when I click on it nothing happens. I have reinstalled the program several times to no avail. *WINE to run the Optus program, however the program doesn't find the HUAWEI USB stick & *Via a Bluetooth connection (use mobile phone as a modem) didn't work either Anyhow, I have tried these and some other ways to get mobile to no avail.
Also, have gone to network connections-mobile broadband-add-configure it- but what am I forgetting to do? Need a path I can take to get mobile internet working. (I even have a direct SIM card slot in this laptop
I am new to Linux. I have recently installed the Ubuntu 11.4 LTS Distro that comes with the Haynes Linux Manual (which I heartily recommend to new users). For the Internet I have a Huawei E1550 dongle on the 3 network in the UK which I'm currently using with Windows XP on my desktop to post this thread. After some initial fumbling, I'm unable to use the dongle with Ubuntu.
View 8 Replies View Relatedi am using ubuntu 10.04. my huawei e1550 usb mobile broadband modem was detected out of the box and was working fine . But after unlocking it with a software,the modem is detected and when i connect ,it immediately disconnects. unlocking was some 'Firmware upgrade' . I tried other distros like pclinuxOs but the same problem prevails. and it is working in windows.
View 5 Replies View RelatedI just purchased a mobile broadband connection from 3 in Denmark. I spent three hours following guides about usb-modeswitch and such. I just couldn't get it to work. Now, finally, I've come THIS far, but yet no internet.
Code:
daniel@daniel-laptop:~$ sudo usb_modeswitch
Looking for target devices ... No devices in target mode or class found Looking for default devices ... Found default devices (1) Accessing device 004 on bus 001 ... Using endpoints 0x0f (out) and 0x8f (in)
Inquiring device details; driver will be detached ... Looking for active driver ...
OK, driver found ("usb-storage")
OK, driver "usb-storage" detached
[Code].....
I'm new here. This is my first post. Something tells me my problem will be met with great sighs and shrugs of shoulders. I think you may have heard this problem just a few thousand times. couple of days ago i took the plunge and installed Ubuntu 9.10. I already run XP Pro. I have the system set for dual booting until i get to grips with Linux and have all that i use daily from software to hardware comprehesively installed and running. then i have this ideal romantic dream of dumping my microsoft heartache, and living a happy life with the new love in town (an OS that works!)
Vodafone (Huawei K3520) mobile broadband dongle. Yes i know its a touchy subject but i am going cross-eyed reading info on various forums from this one to the betavine forums and a detour through vodafone themselves. I just can't find clear concise info on how to get this dongle up and running with Ubuntu. My laptop is Acer Aspire 5633 WLMi. I would really really appreciate your help on this subject i need to get online with this dongle and Ubuntu.
I just installed 10.10 on a my new Aspire One Acer netbook and I got a mobile broadband USB stick from Wind mobile.
The stick is activated because it works on my 20 GB Windoze 7 O.S. but it doesn't work at all on my 140 GB Ubuntu O.S. Both systems are on the same machine so I know it's not a hardware problem either.
Here's what happens: I log on to Ubuntu, plug in the stick and I select the "New mobile broadband GSM connection" in the network connections menu.
From there I selected my country (Canada) and my mobile provider (Wind Mobile) than I selected my plan (Mobile Broadband) and my APN (broadband.windmobile.ca).
Then the stick blinks slowly and the network icon looks forever for a connection but no matter how long I wait no connection ever establishes. My roomate has it working on his HP laptop Ubuntu but no luck on mine. The stick just keeps blinking, a steady light indicates a connection.
My connection is much slower on linux than windows (I'm dualbooting so its easy to test). On speedtest.net I get 0.30Mb/s at most on linux but about 2Mb/s on windows.Torrents does not seem to be affected thou. I've got speeds up to about 150kB/s on Fedora.I'm running a fresh install of Fedora 12 64 bit.
View 4 Replies View RelatedI just want to tell everyone how good the Garmin/Asus A10 mobile phone is as an internet modem.I am in Australia and Mobile internet is an expensive thing to have. cheapest is dodo but i had a few problems trying out a friends usb modem.Anyway i was in the market for a Gps phone and discover this one. it is Android phone and pretty cheap so far it is very good gps, camera, mp3, and phone is excellent.BUT here is the clincher. when you plug it into the computer, the phone screen lights up and gives you 3 options.
View 1 Replies View RelatedI have a Huawei E122 Mobile Broadband HSPA USB Stick on three ireland. i can't get it to connect. but i think the problem might be, when i stick it in nothing happens. it doesn't show up under lsusb. i don't think it "mounts"
View 2 Replies View RelatedI've been trying to make my FC13 Dell d620 work with a Huawei 3G usb modem mode E173. I can not switch the device to modem instead of storage with usb_modswitch. This is what I get on lsusb:
[Code].....
I recently got Tata Docomo 3G Data Card. I was unable to install it on my ubuntu 10.04. My Configuration:
Device: Huawei E367 Internet Device (3G e-stick)
OS: Ubuntu 10.04 AMD 64
Processor/ Architecture: AMD Athlon X2 64 bit (ASUS)
I don't have any other means of internet connection, so that I can download few files on ubuntu 10.04. I got to load all files from Windows and then start from ubuntu.
I recently bought a Huawei EC1261 mobile broadband dongle from Tata Teleservices. Unfortunately,neither does the dongle does not work in Ubuntu 9.04(Jaunty Jackalope) nor in Windows XP. The dongle is rather mounted as a drive and not recognised by NetworkManager as a mobile broadband device. The drive can be accessed with Nautilus as well as terminal like any other USB pen drive and located at "/media/disk". Also, does the device work in Ubuntu 10.04(Lucid Lynx)? report if anyone has tried using the device on Lucid, as I will upgrade to Lucid if the device is supported.
View 9 Replies View RelatedI connect Huawei USB mobile connect to my laptop with ubuntu 10.4 64bit but I cant connect to it when I try to add Mobile Broadband connection .
I see it in lsusb
Code:
lsusb
Bus 002 Device 003: ID 12d1:1446 Huawei Technologies Co., Ltd.
but when I dont know what will i do to enable it and connect with it
I was able to use it normal with my old laptop and ubuntu 9.4 & 9.10 32bit
but with my new laptop I cant use Ubuntu 9.10 with it so that I used 10.4 beta version .
I seem to have a problem with my mobile broadband connection. I have a huaweii e166 usb hsdpa modem. It is veeerrryy slow. It used to work fine in karmic a few days ago, used to get 800kbps (from whatismy.com), now in Lucid the speed test does not even finish sometimes, but if I open the system monitor it shows about 1kbps. Sometimes is gets slightly faster and I can browser a bit more, but then the speed goes down again, to barely useable. I have also setup the modem in xp and whatismy.com speedtest shows 900+kbps constantly. I did a clean install of lucid on my compaq presario cq60 laptop. I have disabled ipv6 and installed the usb-modeswitch_1.1.2-2_i386.deb and usb-modeswitch-data_20100127-1_all.beb but it is still very slow.
[Code]...
Need a bit of help with this have got the broadband side working lovely on Mandriva linux but it should show as a removable drive in fact in windows it shows as two on linux none its as if there not there.Can anyone point me in rite direction to sort this.it sort of see but it just is not available normally removable drives just come up
View 1 Replies View RelatedI want t understand why my 3G modem work only when it's plugged when my computer boot. If I forget to plug it , I need to restart my machine to get it working. I'm using ubuntu 10.04 when I plug the modem during the boot I get the product id changed from 1446 to 141b and dmesg |grep tty show me that the modem attached to ttyusb0 and ttyusb1 when I plug it after the startup I get also the product id changed from 1446 to 141b but dmesg |grep tty show me nothing.
View 9 Replies View RelatedDoes anyone know how to connect to Huawei E122 Mobile dongle? I used to connect to E169 usb stick via umtston.
View 3 Replies View RelatedI'm trying to make a Huawei K3715 HSDPA modem work in Ubuntu 10.04.1. I plug it in, and it loads two mass storage devices (one CDRom containing the Windows software, and one 2GB drive that appears empty), but I don't really know where to go from here.
Note that I replaced the stock network manager with Wicd, as I find it more reliable in picking up wifi connections. I'm not sure if it's suitable for connecting the HSPA modem though.
my HUAWEI E160E Virgin Mobile no longer works after upgrade to Lucid it is detected but the connection no longer works. I tried deleting the connection and trying again but the modem is not detected in network-manager. The modem was working when i was using Karmic and still works on my UNR Karmic Netbook. I have tried various methods but I have not been able to get it to work.
View 1 Replies View RelatedI am trying to use the HUAWEI E1756C USB stick to connect to the internet. Installing usb_modeswitch and usb_modeswitch-data allowed networkmanager to "recognize" the stick and set up a mobile broadband connection.
The result is that NM succeeded in connecting (one of every five attempts) but firefox does not surf, nor emails can be downloaded etc. Just like if not being connected. The USB modem shows the steady blue LED as connected.
A NM issue? I have tried disabling NM control and tried with PPP clients like NMTSMON, wvdial and even Sakis3g. All with the same results. They seem to connect and show flux up and downloaded but no surfing.
resolf.conf shows is pretty much empty and no DNS there.
The working settings in Window$ are:
Same settings with Sakis3G, or NMTSMON or NM result in connection with no action from applications that use the internet.
I have had a similar issue with WLAN each time I change to a different network. I solve that by forcing to update the DHCP. I mean using -su dhcpd wlan0
But attempts like dhcpcd ttyUSB0 or dhcpcd ttyS0 get the same result. So no idea if this is an DHCP, or DNS or another issue.
My box is an ASUS EEEPC 2005H netbook with OpenSuSE 11.2 and KDE
how can i make my samsung e1410 mobile compatible with mobile internet in Ue 2.9
View 1 Replies View RelatedSo, is it possible to set mobile internet as eth0? the reason for this is that etherape and wireshark wont recognize/work with my mobile internet.
View 3 Replies View Relatedlinex,and let me tell you I am very excited to be using linex.Its awsome,I cannot belive how fast my intenet works.OK all I want to know is,whether its possible to connect to my laptop via my mobile, so I can go online when I'm out and about.I don't have blue tooth capabilities on my laptop.so I opdered a wireless bluetooth dongle from ebay.Will I be able to connect
View 1 Replies View RelatedI have a Nokia phone i want to connect it to internet through my PC.
how to do that ?
i recently-ish bought a netbook, and a mobile-broadband toggle to go with it, and set it aside to use later. i promptly installed the Netbook remix on the laptop. Well, I goofed, and didn't notice until well after I bought the WAN toggle that it was made for windows.
so, I downloaded Wine in an attempt to run the start.exe and get my internet. the executable (and the entire drive, i found) are marked by ubuntu as read only. Is there anyway to change this to allow me to run the file? if i did, would it even work?
I can pair my phone and laptop using bluetooth, from Network manager I can select my phone and make a connection. But then I can't access anything.I looked at the connection info from nm and tried to ping the given dns addresses. That failed. And I pinged those addresses when I reconnected with wireless and it failed. So, where are these setup? I didn't do it
View 8 Replies View Relatedlast 6 months i was trying to connect internet on Ubuntu 10.04 yet i don't know how to connect internet i used mobile samsung s3310 with aircel
in windows its required hardware supporting software ,i dont know whether it's required for Ubuntu.
i followed instruction on ubuntu forum that is in
network manger->new connection->mobile broadband connection-> modem type (in that box is not enabled so i cant select my device)
->provider country(india) ->choose provider(Aircel)->billing plan(aircel prepaid ->APN is aircelgprs and dialup number is *99***1#)
->finally i did everything and applied but the network manger not showing any mobile broadband connection i am tired