I have just installed kubuntu 10. My mobo is ASUS p7h55, which hastwo on board sound cards, one for stereo and the other for outputting sound through the hdmi link. When I connect my TV through HDMI, there is no sound. I go to Phonom, and there is only one card in the card selection box.I run aplay -l, and both cards are listed
View 1 RepliesI am unable to get the hdmi audio for from my graphics card to work. I do not have any speakers to test the other two, and redundant, sound cards .My graphics card is the Nvidia gtx 285, I auto installed the drivers via ubuntu. It does not show up in the hardware tab of "sound preferences". It's not muted, I can't find anything relating to sound in nvidia-settings.but here is my aplay -l:Quote:
card 0: XFi [Creative X-Fi], device 0: ctxfi [Front/WaveIn]
Subdevices: 8/8
Subdevice #0: subdevice #0
[code]...
The old Nvidia GT220 recently died in my HTPC and I replaced it with a new GT430. Sound over HDMI worked beautifully with the old card (after much trial & error,) but has now stopped working with the new card.Forgot to mention that everything appears to be unmuted in alsamixer. When I run "aplay -D plughw:1,3 /usr/share/ sounds/alsa/Front_Center.wav" I get no sound. I do however get sound from the headphone jack when I do the same command for the onboard sound card (0,0)
View 1 Replies View RelatedI recently bought a new HD Television, and I wanted to connect it to my laptop, a Gateway NV52 using an HDMI cable. I got the video to work with no issues, but I can't seem to get the audio to work. My soundcard is a Conexant CX20561 and I'm running Ubuntu 10.10.
View 2 Replies View RelatedI have a zotac IONITX motherboard with HDMI video. The video seems fine, but I haven't been able to get the sound working through the HDMI cable. Even the little speaker at the top is gone. It was working fine when I had speakers hooked to the motherboard. I have installed the latest 256 driver from nvidia. If I run 'aplay -l' I get this:
**** List of PLAYBACK Hardware Devices ****
card 0: NVidia [HDA NVidia], device 3: NVIDIA HDMI [NVIDIA HDMI]
Subdevices: 1/1 Subdevice #0: subdevice #0
lspci -v gives :
00:08.0 Audio device: nVidia Corporation MCP79 High Definition Audio (rev b1) Subsystem: PC Partner Limited Device 437b
Flags: bus master, 66MHz, fast devsel, latency 0, IRQ 22
Memory at fae78000 (32-bit, non-prefetchable) [size=16K]
Capabilities: Kernel driver in use: HDA Intel
Kernel modules: snd-hda-intel
I don't know if this is important, but I noticed that it says its running an intel driver for my nvidia sound. Could this be the problem and if so, How do I fix it? Also, if I click on system->preferences->sound it comes up with a dialog box that says that its waiting for the sound system to come up. Why I am not getting any HDMI sound or even the little speaker icon at the top?
I have a Asus EEEBOX EB1012 and everything except the sound is fine. I can use a normal 3,5mm stero plug and get sound, but neither optical och HDMI sound will work. HDMI picture is no problem.I have made sure nothing is muted/not turned on in alsamixerI have tried every "profile" under Sound PreferencesI have tried Alsa upgrade scriptI have tried getting rid of pulseI have tried getting different drivers for the Nvidia cardI have tried Ubuntu 10.04 and 9.10At this point I'm at a loss and don't know what else to do. Has anyone had any luck with HDMI sound on a EB1012 or the ALC662 card?I have several other devices hooked up via HDMI, Xbox 360, Playstation 3, PC (Windows) and none of them are problematic so I'm pretty sure it's related to the ASUS/Ubuntu somehow.
View 4 Replies View RelatedI'm having a hard time with my hdmi output on my HP G60-128CA laptop to my HDTV.For now I'm getting video only with the Nvidia 173 driver no mater if I'm on 10.04 or 10.10. In the 2 cases, the sound is not passing. Let me add that all the options in sound preferences are available and all the speakers tests i did whit aplay worked ( no error messages), and no muted devices in alsamixer.In all my web searching one thing is strange to me: i didn't find a lot of problems regarding the hdmi display output whit the latest nvidia driver
View 2 Replies View RelatedI recently installed ubuntu 10.10 on HTPC, after having a few RAM and SATA issues everything seems to be working fine, The audio (using HDMI) does not work. Have PC connected using HDMI for video (and I am hoping for audio too, this card is made for this and it has been tested with other OS) however the audio does not work, although in the audio preferences it shows to be using the correct hardware. Testing for sound under sound preferences does not play anything, acts as it it was, but no sound, no error messages either. I went ahead and installed ATIs proprietary drivers in hopes that it would make the audio work, but not luck so far.
View 6 Replies View RelatedI'm trying to get my Sound working with HDMI-connection. Got an Nividia 8600M GT on Ubuntu 9.10. Here is what aplay -l says:
[Code]....
Just installed an Asus Xonar DS sound card. Installed the latest ALSA 1.0.23 drivers. The new drivers see my sound card just fine:
Code:
aplay -l
**** List of PLAYBACK Hardware Devices ****
[code]...
recently installed an NVidia GeForce 240 in my HTPC, and finally got it working correctly (as an HDMI-out display) n Lucid Lynx 64-bit.My problem now is that there is no sound, even though sound should be passing through, and I don't know where to begin to fix the issue.
View 4 Replies View RelatedI know there are heaps of sound problem threads around here, and I've been through them all and I still can't my sound to work.I have the motherboards onboard audio which works perfectly when I plug in speakers.I want to use my Creative Xfi xtreme audio. When I select it as the output for my sound, it freezes my audio players and firefox when I try.I don't know what the following means, but this is what ople need from other threads.tim@ubuntu:~$ uname -aLinux ubuntu 2.6.32-22-generic #36-Ubuntu SMP Thu Jun 3 22:02:19 UTC 2010 i686 GNU/Linux
tim@ubuntu:~$ aplay -l
**** List of PLAYBACK Hardware Devices ****
card 0: Intel [HDA Intel], device 0: ALC889A Analog [ALC889A Analog]
[code]...
My laptop is Sony VAIO. I installed ubuntu. However i dnt get sound. My sound card is not working i think. How can i install my sound card here in ubuntu.
View 1 Replies View RelatedNevermind, i just fixed it.Sound card not working?
View 1 Replies View RelatedI upgraded to UBUNTU 9.10 and now my sound card is not working. The card is listed in the sound preferences Hardware but not in the input or output sections.
View 6 Replies View RelatedMy sound card.. TECH-COM PCI 4 sound card isn't working with Ubuntu. I don't know where I can get its driver.
View 9 Replies View RelatedI've spent the last couple hours trying to figure out how to get my SoundBlaster XFi card working, but somehow in the process seem to have now also broken my on-board sound which when I first installed did work. I have no idea how as I hardly touched anything.Both cards are recognized in Sound preferences, sound is not muted there nor in Alsamixer. But neither produce any sound at all now.
Searching around the forums it seems that as of now my XFi should, kind of, work out of the box, but I've had no such luck.I'd really like any advice possible on getting my XFi with headphones to work in 10.04, but if this can't be done I'd atleast like to find a way to fully reset my sound setting so my on-board will work without having to wipe this partition and reinstall - there Must be an easier solution than that.
I have a EMU 1616m sound card and I can not get it to work with Ubuntu 10.04 or 10.10. At the boot sequence I get the message that firmware could not be loaded. However, when I use another Linux distro PARDUS that uses KDE, the card works perfectly. With KUBUNTU i don't get any chance either. I think it is a kernel problem but both distros have the same kernels. So, this is not a KDE vs GNOME problem either as KUBUNTU did not work it either.
View 2 Replies View RelatedI have two sound (or audio) hardware on my desktop computer. One is part of my computer motherboard and the other one is a sound card (CA0106 Soundblaster) I bought to replace the other one. When I first installed Ubuntu, my sound card was working properly after I made the necessary changes (system>preferences>sound), but after a few days it just stopped working and the sound from the motherboard is only working.
I reinstalled Ubuntu to my computer a few days ago, and my sound card was working again, but once again, it stopped working after a few days. How can I fix this?
my creative sound card isnt working with my ubuntuit's my 1st time to use ubuntui have a built in sound card but it's not workingwritten Ectiviai dont have an ectivia soung card
i have Creative and Realtiki want the ubuntu to install the Creative
Earlier I was in windows to do school that I had to do in windows. I shut my monitor to suspend my computer, which disables my sound card. Later on I went back into ubuntu and forgot about it. Ubuntu had updates to the system and since then I have not been able to get my sound to work.
View 2 Replies View RelatedI am using ubuntu 9.10 (kernel 2.6.31-9-rt) and an M-Audio Delta 1010 PCI sound card, and trying to get MIDI inputs and outputs to work on this sound card.I have Jack installed and working. MIDI signals from virtual keyboard or a MIDI player can be routed to fluidsynth, and fluidsynth's audio can be played back through the outputs of the delta 1010.I can use a MIDI sequencer (e.g. rosegarden or qtractor) to record MIDI from virtual keyboard, with jack handling the routing.
But, no matter how I configure the connections in jack, I can't get any signals from the "MIDI In" port on the sound card.Does anybody have some thoughts on how to fix this? Where is the disconnect between the delta 1010 and qtractor? I am concerned also that the "MIDI In" LED on the front panel of the Delta 1010 never blinks. There must be some basic ALSA configuration that needs to be done to activate and use these MIDI ports, or something. I've been trying to figure it out for days.
I am a new Ubuntu user and am having trouble getting the audio to work through the hdmi out to my tv using an Nvidia Ion graphics/sound card.
As far as I can make out Ubuntu recognises the sound card l but i cant get any sound out of it and don't know to go about altering anything.
Im trying to get the sound working via HDMII have a HDMI cable connecting my nvidia video card to the monitor... even i say the apps to output the sound through the device 1,3 , i dont get any sound..
View 2 Replies View RelatedI'm looking to put a new video card in my desktop. I need one that will be able to handle H.264 at 1920x1080, and I would like to find one that can do HDMI with audio. Shopping for video cards, as I heard somewhere, is the kind of thing that makes you want to bang your head against a wall until you go blind, because then you won't need to worry about it any more... someone will be able to recommend a model, or at least a chipset or something, before I rip my own eyes out.
View 6 Replies View RelatedI upgrade from F14 to F15 and at first everything seemed fine, but now I noticed that sound output over HDMI to my TV is no longer working (this worked fine under F14). the hardware in this case is the onboard sound card of my ASUS M3N-H/HDMI motherboard:
Code:
>lspci:
...
[code]...
I have an HP 8510w laptop and I run ubuntu 10.04 out of an external harddrive.
I have no problem getting video over hdmi using the latest proprietary nvidia drivers however I cannot get sound through the HDMI cable.
I have read around without being able to find a solution.
Running "aplay -l" shows only my intel sound card and also there is no hdmi sound interface in the sound preferences (Only the normal output interface).
I am using the latest proprietary nvidia drivers (Believe it to be 1.95) and the graphics card is a Quadro FX 570.
how I can get sound out to work via the hdmi cable?
I have recently installed Ubuntu 10.10. Everything is working fine except I have no sound. When I use the command 'aplay -D hw:0,0 somefile.wav', I can get sound through headphones attached to the headphone jack. But I can't get any sound through the speakers. This is a dual boot desktop and the sound works fine under Windows, so no problems with hardware. The PC monitor is connected through a hdmi cable and I would need sound through the speakers. The output of alsa-info.sh is at
HTML Code:
<a href="http://www.alsa-project.org/db/?f=cb172534097c313b25836f77f2a40fef857102ba">alsa-info.sh output file.</a>
I recently purchased a new video card a GeForce 550 Ti, but I haven't been able to get sound working over HDMI.
I'm running the latest version of Ubuntu (11.04) and have installed the proprietary drivers through Additional Drivers.
Code:
The card is being picked up by alsa and I've configured Ubuntu to use HDMI in sound preferences:
aplay -l:
Code:
When I check alsamixer this is what I see:
ALSA reports that version 1.0.23 is installed, although I thought 11.04 came with version 1.0.24?
cat /proc/asound/version:
Code:
I've tried purging ALSA and reinstalling it but it didn't help. Is there anything I can do? Does anyone know if this card is supported by ALSA properly yet? I hate the thought of having to go to Windows to get this working
i have just recently switched back to Ubuntu and im trying to run my sound through my tv which is connected through my computer using a hdmi cable thats plugged into my EVGA Nvidia GeForce 210 video card ... i have my computer monitor set up as my main screen but i have my tv set up as separate X screen so i can drag over a movie and watch it on the big tv screen and still do things on my monitor ... when i was running windows i was able to get the sound to play through my tv just as i am tryin to do now... does anyone know how i can do this on Ubuntu 10.04
View 9 Replies View Related