Where can I find set up information in order to share internet between my Ipod touch and my laptop? Laptop is connected to cable modem and has wifi interface (so no wireless router).
View 1 RepliesI have 2 laptop with opensuse 11.2. One of them is connected to the Internet through a Mobile Connection with a CDMA/EDVO modem on the usb port. I want to share the Internet connection with the other laptop through the WiFi interface of each of them. How should I proceed?
View 3 Replies View RelatedI've just spent the entire night trying to get my computer to share Internet with my laptop. I have DSL Internet with the modem configured to bridge mode. On the openSUSE server I have two NIC's. When setting up the DSL (pppoe) it created a dsl0 which is using the NIC eth0. So now I have dsl0, eth0, and eth1 I configured eth1 for DHCP server. When I connect with my laptop using DHCP it gets an IP address just fine. However I can't access the Internet. I think my problem is in the Kernel IP Routing Table. Here is the output from /sbin/route -n
[Code]...
dsl0 obtains IP from ISP eth0 is set to DHCP although that confuses me because how can the same NIC have two IP Addresses? eth1 static IP 10.30.60.1
There is a new feature in Windows 7 that make u able to create a virtual WiFi and share ur internet access with many others.
I know there is ad-hoc but sometimes it has problems, for example I couldn't connect to my friend's ad-hoc network (he is using Windows 7) but I _could_ connect to the virtual WiFi he created, it appeared just like any other wireless network unlike ad-hoc
so is there any way to create a virtual WiFi and not ad-hoc in Linux?
OpenSuse 11.4 Asus Netbook 1000H Following other members in the forums I have installed Opensuse 11.4 on the Netbook. In the early days Ubuntu Netbook Remix worked well for me. But this has been discarded, and the "one size fits all" Ubuntu had become slow and cumbersome. So..... onto my post. Opensuse is working well. The install went beautifully.
It detected the Wireless Internet and I am able to get on line. I also need to share the Internet connection to a desktop. This is done via a small network switch. Thus far I cannot do this. I tried to use ifup to configure a static ip but this busted my Wireless configuration. I went back to knetwork manager. Then I tried to set up the wired network using knetwork manager and under IPV4 "share" the connection. But this blanks out any possiblity of a static address and substitutes dhcp. My desktop cannot ping the this dhcp address. Ubuntu had this thing called Firestarter? - from memory. This configured the system to sharing the network.
I often use an Ethernet cable to connect my computer to another computer for various purposes. But when I do that, I cannot use the internet even though I'm still connected to a WiFi access point. I'm presuming that's because openSUSE is trying to reach the internet through the Ethernet cable, which has precedence over WiFi.Is there a way to enable internet usage via WiFi while I'm connected to another computer over Ethernet?
View 9 Replies View RelatedOn Opensuse 11.2, I would like to connect my ipod touch to a wireless ad-hoc network of my laptop. I have no wireless WIFI-router at home, so I have to use the laptop as a router to the internet. I know I have to enter a static IP adres and my router's address, but where ? I haven't found any place under network tools to do this, only saw some fields with SSID's and MAC addresses to fill in.
View 5 Replies View RelatedMy WiFi can connect to internet without any problem, until I plug my ethernet cable ...then I lose internet.
So the question is : how do I configure my ip/dns and stuff to still have internet when I'm plugged by cable at the same time! it was working on windows ;-)
I have a Opensuse 11.4 workstation that has two ethernet ports and I was wondering if there is the chance to use the other ethernet port as a switch to a Mac/PC?
View 2 Replies View RelatedI have a laptop with Ubuntu 9.10. And I want to connect it to Internet using wifi. Also I have desktop with Ubuntu 9.10 (another desktop with Win XP, but for some day it will run under Ubuntu too ). I want one of this these desktops to share wifi with laptop. I think that a wifi adapter is a way to solve this problem. I found a D-Link dwa-110. i've read on forums that someone successfully installed drivers [URL]. Is there any other ways to share wifi with laptop (only 1 laptop needs to be shared with)? Had someone connected desktop with D-Link dwa-110 and laptop (as I want)? Both desktops connected to Internet via wire.
View 5 Replies View RelatedI'm using 11.2 with KDE.
I can connect to the Internet on my WLAN just fine (using Opera) and can dload torrent files (using the same).
However, I have had trouble accessing some community repositories in the past, cannot synchronise with an NTP server (annoying since my battery is low and time and date are reset most reboots) and cannot use the lyrics function or Wikipedia function in Amarok. Nor can I connect to the net using Firefox (though conqueror works just fine...) I cannot download torrents on KTorrent either.
It seems that there is some sort of 'permission'/connectivity issue.
I'm going to an area with no wired internet connection so I would gather information on if it is possible and how to make working the following configuration for an home network:
a wireless access point connected to a laptop (an old one with a centrino Duo) with a usb stick for UMTS connection to the internet it is possible to use the laptop for routing to the internet the requests (http, ftp, mail etc..) of the PC connected to the home LAN which software have I to install on the laptop?
Is this possible? and if so how? Basically the PC in my sig connects to the Internet through a Wireless Adapter..etc. I have another tower PC, running Ubuntu that sits next to it - doing nothing and has no internet connection. (My son uses it to play tux paint etc). I would love to be able to connect the Tower PC to My PC via an ethernet cable? and share the Wireless Connection on my PC?
View 4 Replies View RelatedMy computer running Ubuntu 10.04 (latest) is connected to the internet via an ethernet cable. I would like other devices to connect to the internet by sharing its connection via wifi. Is there a guide to do this? I haven't been able to find one which works out of the box.
View 2 Replies View RelatedI tryed to get network work like this share internet from wifi (wlan0) to ethernet (eth0).So the internet connection comes from the wifi and we share to other computer via ethernet[URL]But when I restarted my pc then it dont work and network says "wired network device not managed" How can I get it work aigan ?[URL]Now I have anohter problem when I connect autoeth then the wireless network dosent work anymore, I have to disconnect eth0 to have wirelles network working. how can I manage to get the bowh to work?
View 2 Replies View RelatedI am a big ubuntu fan (9.04) installed,everything went well, installed my network card(s) & the onboard without no problems/installation disc.I have 2 Network interface(s) that I used on windows xP to 'bridge' my connection, because I only have one slot on my router, and the last slot runs into my computer room and from the PC, I run it to the xbox/ps3.No matter what I do, I cannot get ubuntu to share connection
to my other network interface.
I want to share my internet connexion via ad-hoc WiFi. If it's unsecured, it works fine, but when I use WPA encryption, it doesn't work anymore! I can connect from my iPod touch, but no internet. I connect to the internet from my laptop, via eth0 I want to share my internet connection via wlan0 I have no idea what's wrong
View 1 Replies View RelatedOn ubuntu 10.4, I upgraded my laptop from a fluky Broadcom 4322 wireless card to a yummy Intel 5300. The system recognized the card as far as lspci and lshw were concerned, but it was disabled. I used "sudo ifconfig wlan0 up" to get it active, removed wicd and installed nmanager, and I could access the internet via web browser and mail.
The issue is that other programs (kismet, wireshark, zenmap, anything that I use at my job) do not recognize the new wlan0 interface at all. I've uninstalled completely from synaptic then reinstalled things like wireshark, but under interfaces I get nothing, not even eth0. Nothing looks askew in syslog or the relevant lshw/lspci searches. Does anyone have an idea on this? The Intel 5300 is rolling along without a hiccup so I doubt the issue is there
I've been reading around, but not had much success at all in trying to share the internet connection from my laptop to my phone.all the articles i read refer to earlier versions of Ubuntu and the packages they mention have become obsolete, according to the apt-get tool.im not that new to Linux, but my networking probably isn't up to scratch.if anyone could help me, that would be great, im using Ubuntu 10.04 at the time of writing.
View 2 Replies View RelatedI have a Centos5.4 64bit laptop, having an eth0 and a wlan0. I connect this wired eth0 to a wall socket to access Internet via DHCP (eg the assigned address is like 192.168.192.xx). I do not have access to the ADSL router. How can I turn this laptop into a Wifi access point to allow, say my Ipad or any wireless-only client, to access the Internet thru this laptop ?
That is, communication between iPad to laptop is wifi(ad-hoc connection ??), laptop to the ADSL router is wired LAN. The laptop need to have some bridging build in ? If you can refer me some concepts, then I can follow up from there.
Or better yet, has anybody does this before ?
Since I have 3 Network cards in my Desktop PC I've configured it to act as a Router using GNU/Linux Ubuntu Lucid in combination with Samba so I could share my internet connection. It works on any laptop a connect to it using any of the network cards ports [regardless of the operating system installed on the Laptops], but when I plug that same network cable to any Desktop PC [regardless of the operating System installed] it doesn't even light the LED in the netcards. From the Client PC seems like nothing is plugged in the the netcards.
View 8 Replies View RelatedI want to configure Ubuntu A to share the internet with Ubuntu B so that I can can plug my wireless router directly in the middle of the two computers without having to route all traffic through the router and it having to be connected at one place or the other.
View 2 Replies View RelatedI am running a NFS share on a Debian Lenny server with to network interface.
Sometimes when booting the server the following messages i shown in syslog:
Code:
If the system is rebooted then NFS is functional again. I would like to know way this happens somtimes so i can repair it, anyone with an idea? Another thing is that i would like to bind the NFS service to a specific interface e.g eth1 is this possible?
This may be more suited for the networking forums, but I figured Community Cafe would be well rounded enough for someone to tell me if this is even possible (with minimal configuration that is).There are a few places I travel where I only have a wired connection to the Internet (no wifi), but when this happens is there a simple way to create an adhoc network so wireless devices can route through my computer and to the network? Reason I'm asking is I'm thinking of getting an iPad or iPod Touch which have wireless connections, but in the cases where my laptop is using a wired ethernet connection and the wireless card isn't used, I'd like to create an adhoc wireless network that'll let such wireless devices work.
View 4 Replies View RelatedCurrently I'm dual booting Windows 7 and Ubuntu 10.10 on separate partitions and I would like to know if there is a convenient way to share data between the two without having to set up anything using an internet network .
View 2 Replies View RelatedI am basically wanting to use my Ubuntu 10.10 computer as a router. Note: Before you say just get a router please note that I am poor/cheap. I have two ethernet connections and one wireless connection on my netbook. I want to share the internet connection that is going into one of the ethernet cards through the other ethernet card and the wireless card.
DSL-->1sr Eth --> 2nd Eth (currently works)
DSL-->1sr Eth --> Wireless Card (Adhoc) <--(connects with limited connectivity AKA no internet)
The 2nd Ethernet card already has working internet, but when I connect to the Wireless card (through an Adhoc network), it cannot get an IP (I believe).
Last night while setting up wired & wireless connection in openSuse 11.2 Gnome version via YAST's ifup, I got wireless but lost wired connection (interface eth0). Dmesg shows that eth0 became eth1. I cannot get eth0 back. Is there any way to remedy this situation, eg. get info from the Ubuntu partition in my triple-boot laptop, without having to re-install openSUSE?
View 3 Replies View RelatedI would like to use zypper to update openSUSE 11.2 through the Virtual Terminals (tty1 thro' tty6).
Network Interface is wlan0 (Wireless LAN, home network through a Router) that requires a password using WPA2.
My question is how to start wlan0 through the command-line ?
I just installed Fedora 13 64bit Gnome, but I can't connect to the internet for some odd reason.
If you look at the image below:
I have marked the network icon, but on my desktop I don't have that icon for some reason...
Since I'm new @ Linux(Picking it up again) I went to the services and checked 2 services:
The network manager service was running but the status said: This service is dead.
And the network service was also running but status was: The status of this service is unknown.
I also went to the Administration menu and checked Network, the first tab showed no devices, but when I went to the hardware tab it did show my card.
I also don't believe that this is hardware problem since the card worked just fine under Fedora 9 or 10(Don't remember).
So if anyone got some solutions for me it would be great...
Some related hardware info:
lsusb
Code:
Code:
I have two linux laptops. Currently, I'm using both of them at work, side-by-side. Now the problem is, I'm connected to a wireless router, but the wireless only works on one of the laptops. So I'm stuck with one laptop that has no access to the internet. Both machines do, however, have working ethernet nic cards. So, I was wondering if I could use the laptop with the wireless connection to share the internet connection with my other linux machine and access the internet on both of them. Or as an alternative, just use the internet on the machine without wireless and be able to switch back and forth, that would increase my productivity like 30 fold.
View 5 Replies View Related