CentOS 5 :: Parport_pc Command Line Arguments Ignored During Bootup?

I am having trouble trying to get the kernel to accept some command line arguments for parport_pc during bootup. I have a custom base board with a PC-104 CPU board connected to it through the ISA bus. On the base board I have 3 parallel ports mapped to addresses, 0x150, 0x158, and 0x160. Only the first one needs interrupts, the second two do not. So, on bootup I load the parport_pc module like this modprobe parport_pc io=0x150,0x158,0x160 irq=3,none,none I have been running an older RedHat kernel, 2.6.11 for the past few years and this has been working flawlessly. I had the above modprobe call in /etc/rc.d/rc.local.

Now I am trying to set the system up to use CentOS 5.5, kernel 2.6.18-194.el5. What happens is, the module inserts OK, but the system never recognizes the ports. (i.e, they do not show up in /proc/ioports)
But, if I log into the system, then rmmod parport_pc, then re-modprobe it as above, it works just fine and now my ports are visible. This is an embedded system, expected to just come up and run, so kicking it into action by hand is not an option.

I have tried putting a parport_pc.modules file in /etc/sysconfig/modules so that it will be seen by rc.sysinit, (some site I found while googling said modprobes need to be done earlier than in rc.local),and again, the module gets inserted but the ports are not seen. I have also tried putting rediculously long pauses between each step of the modprobing of the parport stuff;

[Code]...