I am looking for a daemon that will set the CPU to lower frequency if its temperature is going too high. I used an application like this in Windows.
View 3 Repliescpu temp in Suse 11.2 is over than 55 C (sysem don not have any task) , but in windows 7 temp is 42 C
in fedora is 46 C I have new fresh install of suse 11.2 my cpu is : AMD Phenom(tm) II X2 550 Processor
what my system working warm ?
Yesterday I've installed Debian 8.1.0 on my desktop pc. I'm using Nvidia GT 730. After booting, the GPU fan runs at very high speed and really gets overheated. I didn't install any drivers etc.
Is there a solution for this or do i have to switch to Intel/ATI to use Linux? I said Linux, because every distros i've installed makes Nvidia chipset overheated and the fan runs at max. speed.
I'm terrified about making the GPU burnt.
how important it is to setup a Firewall and install Anti Virus and Anti Malware software.
View 1 Replies View RelatedI have a notebook with AMD Athlon 64 QL-62 2 cores CPU. Normally the temperature is 50-52 Celsius in idle but with Ubuntu 10.04 beta 2 idle temp is 60 Celsius. /proc/cpuinfo shows both cores on 1GHz which is good but still temp is higher than usual. I tried to find solution using Google but I didn't find anything.
View 1 Replies View RelatedIf I install Linux Mint 8 or Open Suse , temperature is 48 as windows mostly.If I install any other distro, temperature goes to 80-85 and fan is always On.Ive a laptop dell just bought it, dell studio 15, 4ghz ram dual core etc, a monster for linux but ive this problem, kinda annoying when you wanna have something silent and that doesnt become a furnace.
View 2 Replies View RelatedI have installed the ubuntu 10.04 beta 2. I have notice that it has high temperature. I have try the "top" in terminal. There are no high usage of CPU and Memory. but still get high temperature. same in karmic 9.1. I have been using this ubuntu 10.04 beta2 fresh install just today. I did not do anything or install anything. It gets hot easily after few minutes. It was installed properly and no problem.
2nd problem is I try to reboot then i see the wifi signal and it detects my wifi and also my accesspoint. so I try to connect. I was connected to my accesspoint. My accesspoint is near my side. then I click firefox to test the connection. but no luck. cannot display page. maybe the internet was block even i was connected to my accesspoint. I try to check the signal then I saw (88%).
Well, today I've installed 11.04 on my laptop. Fresh install.I'm getting the following temps (idle)
Code:
Adapter: Virtual device
temp1: +64.0�C (crit = +126.0�C)
coretemp-isa-0000
Adapter: ISA adapter
Core 0: +81.0�C (high = +100.0�C, crit = +100.0�C)
[Code]...
On my linux distro (arch 64bit, kernel .38) temperatures are stuck @ 60 �C in idle!Temperatures were measured by lm_sensors.Ubuntu confirms the issue.My archlinux setup is new; I added these modules after installing cpufrequtils: powernow-k8 for cpu scaling ondemand governor enabled and it is the default governor.cpu scaling is working.No proprietary video driver installed. Using xf86-video-ati/radeon
My suppositions:
a) undervolting not supported/bug/what everelse?
b) proprietary drivers needed?? maybe the high thermal power is produced by GPU and not from CPU?
Ever since I installed ubuntu 10.10, my laptop is shutting down due to high temperature within 15-20 mins. It makes my laptop literally unusable. Had posted the issue, got some advise but the issue didn't get resolved, hence posting again.
Below is previous post.
[url]
Is there any tool or way by which I can check if it's a hardware issue.
On my lenovo g560 i have Intel core i3-330m, i have both debian squeeze and windows 7 installed on my laptop.Today i noticed that while playing music (amarok) and playing a flash game (google chrome, game - tetris, lol (: ) the processor core temperature was around 70-71deg celsius.I restarted and booted windows 7, doing the same thing (music and tetris) the processor temperature is aournd 54-55deg celsius.Can anyone explain why the high temperature when running debian?
View 6 Replies View RelatedMy Samsung R530 laptop is over heating, I believe it is the fan because I can't feel it working at all. When it over heats it just shutsdown. A few times it is came up with a warning while shutting down for a split second saying a extremely high temperature and shutting down seconds later. I am running Ubuntu 10.10 with Nvidia Geforce with Cuda. I have tried reinstalling Ubuntu, installing Fedora... Nothing I have tried has worked.
View 6 Replies View RelatedI have the slight, high-pitched hissing frequency when ever I play back audio.I know other people have experienced this as well, but the threads were in a development section of the forum and are no longer open. Has anyone has the same issue yet found a solution?
View 5 Replies View RelatedI recently upgraded to Ubuntu 10.10 and I am experiencing an ultra high memory usage of the gnome-settings-daemon of 2GB after suspend! Killing and restarting the daemon solves the issue. Anybody else with this behavior?
View 6 Replies View RelatedNot sure this is the right place and I feel really stupid for asking this but, I want to change the frequency of the online update checks but, for the life of me, cannot find out how. During install, I can configure it but I now want something different. I thought that there was a topic with yast under software but no. Only "online update" which basically give me manual update. I click on configure but same screen appears.
View 2 Replies View RelatedI have SLES9.I am running a Java-application named meinServer5.This app starts two application servers, one admin process and one worker process, where the admin process has to be started before and ended after the worker process:
meinServer5 startadmin // starts the admin process
meinServer6 stopadmin // stops the admin process
meinServer5 start //starts the worker process
[code]....
I want to setup a Linux Fedora based Anti-Virus & Anti-Spam Server on my LAN. I have more than 60 Windows users with Proxy Squid running on LAN. Our Email server is hosted on the Internet. Because of virus/spam generate problem, emails are worst affected & the users have a lot of problem on Email, as the outlook gives error. It happens when a PC generates Spam & our IP gets blocked by the ISP for some time. Thats why I want to setup an Anti VIRUS/SPAM Firewall on my LAN (before the Squid), so these spams do not go past the Internet Gateway.Hope u guys understand my problem & suggest some useful links, software & documentations.
View 1 Replies View RelatedHowever, I would like to ask if anyone else is experiencing Higher than normal CPU usage with openSuSE 11.4 PR?? My system, which is probably similar to others, increases the air flow with the fan on the CPU when it is working hard. Mine gets rather noisy. (don't have it on the floor, but right next to me) This fan speed increase has been lots more prevalent in the newest version of openSuSE.
Have also used 'top' and it looks like xorg is one of the biggest hogs. However, when I use VMware it goes into hyper drive a lot.
After I login my desktop preferences are not loaded. If I try to change them (Control cneter-> apparence) I get a message that says: Unable to start the settings manager 'gnome-settings-daemon'.Without the GNOME settings manager running, some preferences may not take effect. This could indicate a problem with DBus, or a non-GNOME (e.g. KDE) settings manager may already be active and conflicting with the GNOME settings manager.The first lines of .xsession-errors show:
/etc/X11/xim: Checking whether an input method should be started.
HOSTNAME: Undefined variable.
XDG_DATA_DIRS: Undefined variable.
[code]....
I use opensuse 11.3 and would like to see daemon status at boot time, instead of the chameleon with a progress bar
View 8 Replies View RelatedI have a problem with my screen resolution in Linux. This happens with both openSUSE 11.4 and Fedora 15. The moment my PC restarts after I have installed the operating system it will boot up with a screen resolution higher than my monitor supports. My screen supports a maximum resolution of 1600 x 1200 @ 75Hz and Linux sets the default resolution way too high at boot, now all I get is a message from my screen asking me very nicely to change the signal timings, but I can't because I can't see anything to change it to a lower value (I don't want it so high anyways because then everything is too **** small). My monitor is a SONY GDM-5410 and the Graphics card is an AMD Radeon HD 4870 1GB. It nly works when I boot the system to FailSafe mode, but then I can't cahnge it permanently.
View 1 Replies View RelatedI just installed 11.2 and my processors are running at 62% all the time. There are no obvious processess in th system monitor using so much processor, there is none over 8%, the highest is system monitor itself.Then I am trying to make the Broadcom wireless driver but I get the next error:
KBUILD_NOPEDANTIC=1 make -C /lib/modules/`uname -r`/build M=`pwd`
make: *** /lib/modules/2.6.31.5-0.1-desktop/build: No such file or directory. Stop.
make: *** [all] Error 2
Is there any way to get openSUSE 11.2 to automatically shutdown or hibernate when the laptop is overheating? I often cannot tell when my computer is overheating as it sits on a table. When it over heats, the kernel panics and I have to hold the power button to force my computer to shut off.
View 4 Replies View RelatedI tried to add my wife , and when I put in a password for her, this error comes up."Please set a valid user name consisting of a lower case letter followed by lower case letters and numbers." I did all that and I still can't set a password for her.
View 3 Replies View RelatedI was hoping to install Fedora 15 x64 on my desktop on a seperate disk from Windows. I have tried about 15 times so far and keep getting errors. The same type of errors occur when trying Ubuntu 11.04 x64.
This is the spec of my PC:
Core i7 920 oc'ed to 4.00ghz (stable in Windows with temps under 60 degrees celcius at load)
Asus Rampage II Extreme
Sapphire Radeon 4890
6gb Ram
Install disk is an empty WD Caviar Black 1TB (Also, not sure if this is relevant, two soundcards - M-Audio Audiophile & Asus Xonar)
This is the error (I can't get it all written down because it reboots too quickly, so I've written down a selection):
SPU 4: Machine Check Exception: 4 Bank 5: be000000000800400
TSC 564..
And lower down the error: No human readable MCE decoding support on this processor type
I suspect this is due to overheating because when I boot back into windows the cpu temp has risen to 80+.
Is there going to be any way to get Linux on this machine without frying the processor?
i recently installed ubuntu 11.04 on my toshiba satellite p200-1k8 laptop; with ubuntu the fans were always running at full blast and the laptop would overheat and shut down even though i wasn't using the computer for anything intensive, e.g.just browsing videos. i installed opensuse thinking the problem might have been with ubuntu but in suse as well the fans seem to be running full blast right from start up and the laptop getting quite hot. i've now learnt this is a generic problem with toshiba satellite laptops and linux, something to do with acpi and possibly the ati graphics cards? my gpu is an ati mobility radeon 2600 if thats any help. in windows (which i was last using two days ago) the fans and heat from the laptop were nowhere near this noticeable and i didn't experience this overheating problem just browsing the web.
could anyone recommend any fixes to better the heat management of my laptop on linux (apart from cleaning the fan which i've already tried )?
I have an overheating problem of my laptop (HP Probook 4710s) graphic card while watching movies, for example. It just powers off after watching a movie for 10-15 minutes and it's very hot if you touch it. Gkrellm shows 82C for GFXZ and 72 for CPU.
I installed the last ATI drivers from the official website but it didn't have any effect.
However, it works without any problems on Windows 7 (x64 edition).
Here is some data from Hardware Information application:
34: PCI 100.0: 0300 VGA compatible controller (VGA)
[Created at pci.318]
Unique ID: VCu0.u_Zo3GB+OPF
Parent ID: vSkL.6um+del2fP5
[Code]....
i have dual boot windows xp and Ubuntu 10.04 so i was wondering if it is necessary to install an anti-virus software?
View 9 Replies View RelatedI'm running Windows xp as a guest on virtualbox. Is anti-virus software recommended?
View 9 Replies View RelatedThere is a question, i'd like to ask: is there any decent program to monitor HDD temperature for linux? WHy are they so few? Suse Install repositories do not show any that could be installed. I used to use hddtemp on my previous 11.2 gnome installation, but it seems now something gone wrong, and i cant get this program anymore through: "sudo apt-get install hddtemp" and receive "sudo: apt-get: command not found", so as i am a newbie i can barely guess what is wrong. maybe there are any other programs to get this thing running. Its really puzzling because every laptop user need such tool badly, and i do not understand why is there so many monitor tools for cpu temperature and not a single good for hard drive which is far more important than cpu temperature, that rises and drops constantly as soon as your fans are fine???
View 2 Replies View Related