Networking :: Implement Openswan In RedHat5 - Pluto Not Running

When implement openswan in redhat5 and start ipsec appear this problem
whack: Pluto is not running (no "/var/run/pluto/pluto.ctl")
what this file contain

and when run this command
ipsec verify
Checking your system to see if IPsec got installed and started correctly:
Version check and ipsec on-path [OK]
Linux Openswan U2.4.10/K2.6.18-8.el5 (netkey)
Checking for IPsec support in kernel [OK]
Testing against enforced SElinux mode [FAILED]

SElinux is running in 'enforced' mode. Since no working SElinux
policies exist for Openswan, SElinux should be disabled.
echo "0" > /selinux/enforce (or edit /etc/sysconfig/selinux)
NETKEY detected, testing for disabled ICMP send_redirects [FAILED]

Please disable /proc/sys/net/ipv4/conf/*/send_redirects
or NETKEY will cause the sending of bogus ICMP redirects!
NETKEY detected, testing for disabled ICMP accept_redirects [FAILED]

Please disable /proc/sys/net/ipv4/conf/*/accept_redirects
or NETKEY will accept bogus ICMP redirects!
Checking for RSA private key (/etc/ipsec.secrets) [DISABLED]

ipsec showhostkey: file `/etc/ipsec.secrets' does not exist
Checking that pluto is running [FAILED]

whack: Pluto is not running (no "/var/run/pluto/pluto.ctl")
Two or more interfaces found, checking IP forwarding [FAILED]

whack: Pluto is not running (no "/var/run/pluto/pluto.ctl")
Checking NAT and MASQUERADEing [OK]
Checking for 'ip' command [OK]
Checking for 'iptables' command [OK]