i'm using dell n4010 laptop and recently i installed opensuse 11.3. There is a problem. My Wifi is not working. I think my WLAN card is not detected. What to do?
I will like to know how to install ethernet drivers dell inspiron N4010 on opensuse 11.3, when I go to YaST > Network Devices > Network Settings and then I have a Warning message "Network is currently controlled by NetworkManager and its settings cannot be edited by Yast. Then I click on OK, I go to Global Options and i click on Traditional Method with ifup, and then I go to Overview and I have this information:
Name IP Address Attansic Ethernet controller Not configured Broadcom WLAN controller DHCP
This is my first time using openSuse, I previously install Ubuntu and I had some similar problem with the internet I hope fix that problem as soon as possible and keep using openSuse. Other thing is that I don't have any internet connection with this laptop even wire or wireless connection.
I recently purchased a dell inspiron N4010 with windows 7 preloaded...i want to install fedora into it and i want keep it as my primary operasting system.... but what worries me is that the windows setup files is stored in a hidden recovery partion.... So if i install fedora will i lose this ??? if no will i will be able to install windows from that partion?
I installed 10.04 today, not having used this system for Ubuntu since 8.04. My wireless card (Texas Instruments ACX 111) worked perfectly in Windows XP and 7, and it worked on installation in 8.04.
I did a clean, full install of 10.04 (no dual boot or anything), but the wireless card is not working. The OS doesn't even seem to recognize that it is there because I can't even scan for networks, let alone connect.
The only reason I have a connection on this computer is because I am sharing the internet via ethernet from my Macbook.
I tried using b43-fwcutter in accordance with the Ubuntu Forums and nothing happened, and then I decided to look a little further. According to LinuxWireless.org, the BCM4306/2 actually uses the b43legacy drivers, so I purged all of b43-fwcutter along with firmware-b43-installer and downloaded firmware-b43legacy-installer.
Nothing happened, so I downloaded b43legacy manually per the instructions listed at LinuxWireless.com, and manually extracted from wl_apsta-3.130.20.0.o to my /lib/firmware folder. Nothing happened again. I made sure to check additional drivers and nothing shows up.
As per the ticket posting instructions, I've included all the info you guys could need. from what I can conclude, the wireless isn't even ON, but it's integrated and I have NO IDEA what I have to do to get it up and running.
At least in OpenSuSE 11.3 LXDE I was able to get the wireless on, although I had some major connection issues, I guess it couldn't resolve the handshake completely, or take my SSID/PSK properly.
I am using a dell laptop which has Dell 1397 802.11B/G Wireless Mini Card. I not able to connect to internet and was not able to detect what actual problem is weather card is not supported (i.e. drivers are not available) .
Also, if any one can point to exact process to connect to wireless Lan using fedora12.
Program Knoppix 3.1 cdr Computer Dell 2600. Floppy start up yields a stopped functioning computer with the following line: "Probing SCSI... aic7xxx0" At this point the computer is locked up and I have to turn it off. A restart causes the same action.
I wiped and loaded my mini. ran the ubuntu 10.04.. had to run hardware drivers twice to finally get reference to broadcom and then wireless came on!! Hurray! however (yes, dhcp).. no dns on wireless but on eth0 no problem everything shows up ip, dns.. works fine.. go to wireless it connects, gets ip but in connection information no dns servers listed
Its a Dell Inspiron 1300 Laptop. 1.8GHz Pentium M, 2GB RAM, 160GB HDD, and some form of Intel graphics. The wireless card in question is a Dell TrueMobile 1300, with a BCM4306 Rev02 chip.Installed 10.04 LTS, updated it all on wired connection, then enabled the bcm43legacy drivers that were in the Hardware Drivers box, and it all worked fine. First thing I did was try to install some media codecs, and noticed they went slow on wifi, and swapped to the wired connection again. I thought it might just be slow servers, but I instantly got an extra 200kbps just by wiring. I try browsing the web, but its extremely slow and sometimes Firefox stops responding. I then begin to install WINE, and it complete stops loading, so I watch the net traffic when I hit a search in FF. Nothing goes out. I hit it a few times more, and finally it'll send something and receive something, but still VERY SLOWLY.
Its not a local problem, as other computers and laptops can connect fine with good speeds. Just wondering if this is normal, or if there's any other drivers to try, or if there's something I'm doing wrong here. I'm kind of a linux noob, but I'm for defs not a computer noob. But since I can't be guaranteed the drivers work with my specific card, who knows?
I have an Inspiron 1300 and have followed the "B43" instructions here:URl...Plus various other guides including the "one click b43 fix" but nothing useful happens. Wired access doesn't work either.
I'm new to ubuntu. Recently installed 10.10 on my dell inspiron 1546. The bluetooth does not seem to be working. In the bluetooth preferences window it says "bluetooth is disabled" and pressing the "turn on bluetooth" does nothing.
lsusb shows nothing. hciconfig -a shows nothing.
Bluetooth is enabled and working in windows 7 with up to date drivers.
ISSUE SOLVED: FOUND SOLUTION ON LINUX MINT COMMUNITY[URL]... The solution is for debian, but it worked for me on Kubuntu 11.04. I just installed Kubuntu, and my wireless is not getting detected. I tried a variety of solutions I found online, but none worked. It worked perfectly for Ubuntu Gnome.
When I tried installing the Broadcom drivers in the "Additional Drivers", I got an error that the driver could not be installed.
The network icon and sound icon disappeared from the panel all of sudden one day while i was using ubuntu 9.10 and the network got disconnected. It used to work fine before when i was using ubuntu 9.04 and even after i updated to 9.10, but then that happened. I added the notification area back to the panel but now ubuntu cannot even find any wireless networks. When i connect a LAN cable to my laptop the internet works fine, but the wireless networks area in the network icon is grayed out and it doesn't show any wireless networks. I'm using a Dell Inspiron 600m laptop and my network card is Intel Corporation PRO/Wireless 2915ABG [Calexico2] Network Connection (rev 05).
I have recently installed Ubuntu 9.10 but am unable to connect to any of the wireless networks. Network manager does not shows any of the available wireless networks and upon clicking the network connection icon, under Wireless networks category it shows "Device not ready".Following are the results of some of the commands :
iwconfig lo no wireless extensions. eth0 no wireless extensions. wmaster0 no wireless extensions.
I'm running Ubuntu 9.10, Dell Inspiron 1545. I have the NDISwrapper installed, and the driver shows up in "Hardware Drivers" as activated (Broadcom STA wireless driver) it also shows up in "Windows Wireless Drivers" (bcmwl6) but it still won't allow me to connect wirelessly.
I have read this: [URL] I have been trying to set a static IP address for my Dell XPS 8100. It has a wired and wireless connection. DHCP worked fine for both of them. My goal is to set up Samba and some other things that require a static IP. My /etc/network/interfaces file looks like this:
[Code]....
If I take the eth0 interface down, I can connect to the internet sudo ifconfig eth0 192.168.1.154 down Which is really puzzling because I think that I am setting both interfaces in the exact same way. What am I missing?
I am having trouble in getting the wireless up in Ubunto 10.04. Under Wireless Networks it says "wireless disabled". I have a dual boot with Windows 7, installed Ubunto with the help of Wubi installer. My laptop is Dell Inspiron 1545, with a 64 bit architecture.I have already done checking and enabling the wireless driver by going to System- Administration-Hardware Drivers and choosing Broadcom STA driver.
I've got a Dell Inspiron 1545 with wireless card Dell wireless 1397 802.11g. It was working fine with Windows and Ubuntu 9.04 (I've got the two OS installed alongside). But as soon as I upgraded my Ubuntu to version 10.4 I realised it lost its wireless connection! I updated the system, the hardware driver for Broadcom STA wireless driver is activated and in use (according to Ubuntu Hardware drivers checker) but the fact is that I can only connect on the Internet if I hook the net cable on it, when I run the mouse over internet connection icon at the topright side of the monitor I see "no network" message and when I left click on it the option "wireless network" it's disabled and gray. How can I get my wireless card back working?
I was praying a standard install of Ubuntu 10.04 would work out of the gate and I was wrong:- Looks like everything is working except for my wireless adapter, Dell E4300
i have to say that i'm not too familiar with Ubuntu... or Linux in general . I've installed it once, just to test it out but I didn't know how to use it so i just reinstalled windows. The other night, i was bored and decided i wanted to re-try Ubuntu and to my suprise, i found Wubi. I love ubuntu now and i made the decision to permanently switch over to ubuntu.
At first, my wireless wasn't working, but there was a quick fix. All i had to do was go to the Synaptic Package Manager, Reload, and search for "Broadcom." I installed the Broadcom STA Wireless driver and i was online within a couple of minutes. I then played around for a couple of hours before turning my laptop off. But, this morning, when i turned it back on...I coudlnt' connect. When i click the little connection icon in the top right, i see the message "Wireless is disabled".
There is a key on my computer that turns the wireless card on or off, and i have tried it. It doesn't work. I have reinstalled the broadcom driver and it doesn't work. I've rebooted...And it doesn't work. I don't know enough about linux to get a solution and every other solution i find on the internet doesn't work.
I have seen in other threads that you guys usually ask for a a couple of things from the user. ifconfig and the sudo lshw -C network so i have included them below. I also looked into the ubuntu help documentation and it told me to do the lspci command.
ifconfig
Code: eth0 Link encap:Ethernet HWaddr a4:ba:db:d1:61:c2 inet addr:192.168.1.68 Bcast:192.168.1.255 Mask:255.255.255.0 inet6 addr: fe80::a6ba:dbff:fed1:61c2/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
I've recently partitioned off a section of my hard drive to run Ubuntu from and I'm having trouble with the network connections. In my device manager of Windows 7, it lists that my network adapters are
1. DW1520 Wireless-N WLAN Half-Mini Card
2. Intel(R) 82577LM Gigabit Network Connection
Is there something I'm not doing right in order to allow me to connect to a wireless connection? Are these devices even enabled in Linux systems?
I'm running on 11.04 on my Dell Inspiron 1764, and so far haven't been able to achieve internet access through either a direct wired connection or wireless.
My wife's laptop is Dell Inspiron 6400 running 11.04. Wireless has recently stopped working. Running rfkill list all shows dell-wifi hard blocked no soft blocked no. The fn plus F2 keys toggle status between blocked no and blocked yes, but network manager still can't see network. I've tried removing the Broadcom STA driver - no joy.
i have a dell inspiron 15r that i plan on running fedora on, however, today i booted fedora from a live cd and it was completely oblivious to the fact that i have a wireless card, obviously i need certain drivers for it, problem is i dont know what drivers those would be, or where to get them, http://www.dell.com/us/business/p/inspiron-15r/pd this is my laptop model, and it says i have a "Standard Dell Wireless 1501 802.11 g/n" wireless card, if anyone could tell me how to get this working,
