General :: Getting More Than One Udp Packet To Remote End Using Sendmsg

I am trying to send data via UDP using sendmsg on the sending side, and recvfrom() on the receiving end.The setup for my data is to have an iovec that has a packet hdr, followed by an iovec that has a payload, then to have subsequent sets of these two types of iovecs. On the receive end, I have a while true loop that does a recvfrom() receiving a size of 1 hdr/payload combination.When I do send out a message that has a total of just 4 iovecs (hdr/payload/hdr/payload) and I use recvfrom on the remote end with a receive size of a hdr/payload set,only the first hdr/payload of the sendmsg is received.I was under the impression that using this while true loop would allow me to receive multiple sets of this hdr/payload combination that is sent out by sendmsg().