I keep losing my Internet Connection(DSL) very quickly. Usually after a couple of minutes, it's absolutely unpredictable. And then, it gets difficult to reconnect. And if I succeed in reconnecting, I again lose the connection quite quickly.
Here are some logs from the ifcfg-dsl0.log code...
I want to be able to connect these machines to the domain and use active directory on them.
View 2 Replies View RelatedOpenSuse 11.4 Asus Netbook 1000H Following other members in the forums I have installed Opensuse 11.4 on the Netbook. In the early days Ubuntu Netbook Remix worked well for me. But this has been discarded, and the "one size fits all" Ubuntu had become slow and cumbersome. So..... onto my post. Opensuse is working well. The install went beautifully.
It detected the Wireless Internet and I am able to get on line. I also need to share the Internet connection to a desktop. This is done via a small network switch. Thus far I cannot do this. I tried to use ifup to configure a static ip but this busted my Wireless configuration. I went back to knetwork manager. Then I tried to set up the wired network using knetwork manager and under IPV4 "share" the connection. But this blanks out any possiblity of a static address and substitutes dhcp. My desktop cannot ping the this dhcp address. Ubuntu had this thing called Firestarter? - from memory. This configured the system to sharing the network.
I'm using Xubuntu 8.10, network-manager, Atheros AR2413 802.11bg NIC, and Radeon Xpress 200M with open-source ati drivers.
My problem is that I'm frequently losing my internet connection--whether I'm wired or wireless. It happens most often when I'm watching a ..... video but it happens other times too. My cpu usage is high when watching ..... (70-100%), so that may have something to do with it but I'm here because I really don't know.
I started having this problem when I switched from the proprietary fglrx driver to the ati driver. I switched because my laptop was always freezing halfway through a movie using vlc/mplayer. The ati fixed this but gave me my current problem. I do not want to go back to fglrx.
Here's what I've done so far to try to fix it without success:
-tried using noapci boot option
-tried using a different router
-tried using wicd
When I lose the connection I still have a strong signal. My lshw and iwconfig outputs are the same as before I lose my connection. However, I cannot ping my router when I lose the connection. I have to reboot to reconnect.
I just installed fedora 10 on a machine with a netgear ga311 gigabyte Ethernet card. Usually when I start it up I have a connection but after 5 minutes I lose the connection.
View 4 Replies View RelatedMy imac is connected on a wired connection and it keeps losing signal it will work fine for the first couple of minutes
View 3 Replies View RelatedI installed Suse 11.2 on clean HD. I cannot connect to the internet. Seems like Suse didn't install drivers for on board ethernet card. It is a Marvell Yukon 88E8056. I'm new to this and don't know how to install the drivers.
View 3 Replies View RelatedI have SUSE 11.0 set up to act as a router/firewall for my home network to the internet through a cable modem attached to an Ethernet card. When I was laid off several years back, I found information that let me connect my network to an ISP via a standard serial modem. I am considering going to the Sprint U1901 4G USB modem and dropping cable internet. Sprint claims the U1901 is Linux compatible. My thoughts are that using the 4G modem should be similar to the old dialup modem. I had a script that connected to the internet whenever internet traffic was detected. Unfortunately, I did not save notes on what I had done to setup the modem to dial automatically, and I have been unable to locate information that seems good to set this up again. I already know that all I had to do to get routing working was simply replace the internet port in the firewall/routing script with the port for the modem. So I assume that is rather trivial.
Would you please point me to a doc, perhaps SuSE specific, that gives reasonable directions on how to set up a "dial on demand" ISP connection? I assume that the 4G modem will be very similar to my old serial modem so that a dial on demand script will work. I did find a dial on demand howto, however, it did not seem to apply.
I am running Karmic AMD64 on a homebrew desktop PC, but I also previously had this trouble on 32 bit with different hardware and on Ubuntu 9.04 and 8.10. The router is now an ADSL+ Thomson TG585n supplied by O2 and badged O2 Wireless box III. The PC has a direct ethernet connection. The router was replaced by O2 when the problem first appeared, as the Wireless box II was suspect. However, I still have the problem and it is getting more frequent.
The symptoms are these: I generally shut down the PC each night, and only fire it up again when needed, which is usually the following evening, but it remains on for most of the day at the weekend. Very often when started, I find I have no connectivity to the internet, and cannot retrieve my emails. Strangely though, the Skype connection is still present and works, although not every time. My wife's laptop is connected over the wireless link - and that STILL WORKS! Sometimes I can connect to the router interface, but sometimes I can't. I've never lost the connection while the PC is running.
I have tried everything I can find in the router (when I can connect) and also in the Systemreferences:Network Connections and also in System:Administration:Network Tools, but can't find anything that helps. A re-boot of the PC doesn't help. A re-boot of the router doesn't help. A hard reset of the router on it's own doesn't help. The only solution to restore the connection is a hard reset of the router (using the recessed reset switch in the back) followed by a re-boot of the PC.
Since the Skype service remains working, and the lights on the router remain normal and wireless service doesn't fail, I think this has to be a DNS server problem. In the previous release, Jaunty, I changed the DNS service to OpenDNS within Ubuntu, overriding the router's settings. That seemed to help a great deal, although there was still the occasional outage which might have been another cause. I can't find anything in the GUI interface in Karmic that will let me do this, and I can't now remember how I did that in Jaunty.
In short: browsing the internet with domain names does not work. The long version: I've configured my network with DHCP and ifup. Ping works on my internal net and with servers in the internet. Dig work's too! I get the right IP to the requested domain. When i try to access the internet using firefox or even wget i get an DNS error. For example wget is showing the following error: Resolving heise.de... failed: Name or service not known. wget: unable to resolve host address 'heise.de'
Again dig show me the right IP and if i add the entry to /etc/hosts it work's too! I've even tried it with manually setup of ip address, nameserver and default gateway but with the same result. Switching off the firewall has no effect on this problem, too.
Since I installed Ubuntu I've had this problem that makes me loose connection to the Internet. The wireless-icon on the panel starts loading, and after like 5 minutes, it works again.I had this problem when I had Mint 11, but it happened more often.Anyone know how to fix? Edit:Network: Card-1 Atheros AR9285 Wireless Network Adapter (PCI-Express) driver ath9k Card-2 Marvell 88E8040 PCI-E Fast Ethernet Controller driver sky2
View 2 Replies View RelatedI install from openSUSE-11.3-NET-x86_64.iso. Installation was succesfull, but after install all packet on test internet / update was error. And after log in in installed system internet not work. I use router with DHCP
View 8 Replies View RelatedI'm on opensuse 11.4 (11.3 won't work with my monitor).
My computer gets internet through wireless and I want to share that internet through its ethernet port. So far I've tried using Knetworkmanager to create a network bridge between my wireless and wired connections. I created a new wired connection and shared it using the ip address settings. I was able to get both connections active, but the device hooked up via ethernet had no internet connectivity.
I also tried this command:
echo 1 > /proc/sys/net/ipv4/ip_forward
but another test resulted in the same fashion (no internet on wired). I believe anything I add to /proc should have an immediate effect, correct?
I have a desktop computer running OpenSUSE 11.2 with two network cards installed. I would like to use both cards for connecting to the internet using different networks. The setting would be the following: eth0 is the main (default) card, almost all programs should use this NIC for connecting to the internet. eth1 is used only by a few programs, which have setting for selecting which network interface to use. The two NIC's are connected to different networks, so the IP address of the NIC's, the related subnet masks and gateways are also different.
Saying short, I would like to have the two NIC's as they would be in two separate computers. I can set the IP address and subnet mask of the NIC's. The main problem is that I can only declare one gateway. How can i setup this? I do not use network manager, I configure network cards using yast, but if needed I can of course use ifconfig directly.
I'm having a strange problem with my network connection/DNS. I turn computer the on and it recognizes and connects to wireless or wired but I can't access any Internet resources or my router. If I ping the default gateway, I get no response and I get DNS errors from any network services that run at start up. If I stop and start the network daemon then it all works fine until the next time I turn on my laptop. It does this for both wireless and wired connection.
I've tried to edit the network interface information in YaST but it says that configuration is handled by knetworkmanager and I have no idea where that information is accessed. I should point out that it all worked fine until I tried to connect to open WAP at my school and couldn't so I connected to the wired network. Next morning I had this problem when connecting to my home network. My questions are 1. What could be the cause of this error and 2. where does one configure the network interfaces when using knetworkmanager
I often use an Ethernet cable to connect my computer to another computer for various purposes. But when I do that, I cannot use the internet even though I'm still connected to a WiFi access point. I'm presuming that's because openSUSE is trying to reach the internet through the Ethernet cable, which has precedence over WiFi.Is there a way to enable internet usage via WiFi while I'm connected to another computer over Ethernet?
View 9 Replies View RelatedI have no Internet Access with Firefox
I first tried an upgrade from 11.3 to 11.4 and lost Internet Access, so i re-loaded 11.4 from scratch on clean partitions.
I am connected to my wireless WPA2/PSK connection, have an IP, am able to see the network.
I turned off and disabled the SUSE firewall.
I tried setting Firefox proxy settings to auto and to none, i dont use proxy.
I am currently posting this through an SSH connection to my 11.1 server from the new install of 11.4 on a Dell latitude D600 laptop (not using the on-board Broadcomm that is an issue for a later date).
I am running out of ideas anyone got a clue.
how to connect my network data card to run internet on openSuse..
View 4 Replies View RelatedI have wired ethernet to my laptop. I want to be able to share my network connection with my iphone.
I have set up masquerading:
I have configured my wlan0 to a static IP - 192.168.1.100/24 call iwconfig to configure wlan0
I see the network pop up on my phone, I configure my own statis IP there, 192.168.1.100 as gateway
Success - I can connect to google for about 30 sec.
If I check iwconfig again, there is no longer a essid specified but a "CELL" value instead - and this is changing every 10 sec or so.
With the above I'm quite happy that I've configured everything OK except for iwconfig - why is it dropping my config?
I've a broadcom wifi nic and I'm using ndiswrapper.
the thing is that I cant use Network Manager to connect to Internet, because it simply do not connect. The connection, although, awailable throught yast when i choose "traditional method with ifup", so everything is just fine, but if i need to reconnect, i have to reboot. How do I setup a !working! connection through Network Manager, or maybe i do not do something properly.
View 5 Replies View RelatedI'm new in SUSE 11.4. My problem is: I'm using Alfa AWUS036H card. It's recognised and I can establish connection to my network, but cant get to Internet. I can't surf the web cos Firefox tell me that connection is timed out. Now I'm confused why I can't surf the web even if I'm connected. Also, I trayed to instal linux drivers for this card folloving Ubuntu "how to" and it just dont work.
View 4 Replies View Relatedlost my internet connection on fedora 12 ? i try to assaing the ip address manual in the configruation part but no nothing happen I've tried googling for the problem
View 4 Replies View RelatedI have a Windows 7 Ultimate x64 machine networked with my Lucid machine. When I reboot my Windows machine, the only way I can access the shared drives is to also reboot the Lucid machine. Can anyone tell me why this is, and, more importantly, how to make it stop that?
View 1 Replies View RelatedKtorrent frequently quickly flashes a message, which I believe says something like :
klauncher unable create io-slave for kde proxy
I have problems in connecting to the internet.I have a new desktop.I installed the opensuse 11.3 64bit.I connect to the internet without any problems.I've installed the necessary update files.I continue to use it without problems.But today I cannot connect to the internet.I opened my desktop with Ubuntu CD and I could connect to the internet.I installed the opensuse 11.3 64bit again.Problems continued.I've written a static IP.
View 5 Replies View RelatedI am trying Open Suse 11.2 KDE Live CD and don't know how to connect to the Internet. What do I do?
View 9 Replies View RelatedIs there a network trouble shooting guide for OS 11.2 that I could follow? I've shot myself in the foot so I should try to fix it.
I changed the DNS server addresses and the number of IP addresses on my router. I then set my Linux system to use static IP addressing and edited the network settings for my network adapter accordingly. I can now no longer get to any web-site.
By contrast, I also updated 1 of my Windows computers in a similar way; it continues to work without problem.
I am trying to get internet connection on Open Suse 11.2 through my wireless connection. I can connect to my network but there is no internet connection. The internet connection does work with other Linux distros and with Windows 7 laptop and Windows XP machines. I tried turning off the firewall but still no connection. What is even stranger is I can ping Google but in Firefox I cannot go to Google.
View 1 Replies View Relatedi just installed opensuse 11.2 and there is no internet and i have no idea how to get it.im using a comtrend dsl modem and i figured it would just auto detect but i did not.
View 1 Replies View RelatedIt is just 3 days that I am using Linux Opensuse 11.2. I got a problem with Internet connection: I have HUWAEI E1550 3G Modem, but I have no idea about using it on Linux OpenSuse 11.2. Now I use it Windows7, there is no problem, because there is a program and driver for modem.
View 1 Replies View Related