Networking :: Gigabit Switch Causing Network To Freeze?

We have an old Zonet 10/100 switch in our home network that locks up whenever there's a power glitch longer than about a microsecond. (OK. It's not that bad but if the lights flicker, I usually end up going down to the basement to see if the switch is hung.) None of the computers or peripherals are affected by the glitches, BTW. Power-cycle the switch and everything starts working again. After putting up with this for months I finally picked up a Netgear 8-port 10/100/1000 switch to replace the Zonet. Unfortunately, when the Netgear switch is in the network, everything slows to a crawl before completely freezing up. Pinging other systems barely worksname would not work.Pinging another system by its IP address worked a little but packet losses of 70%-80% were the best I saw. At first. Then it gets to where the loss is 100%.

All systems were rebooted after the Netgear switch was inserted into the network. The systems that were capable of gigabit connections autosensed the new switch and set their port speed accordingly. And that's about all that works when the Netgear switch is present. (The Zonet is back in the network now.)One thing I have not tried is forcing the port speed on the gigabit-capable systems to 100Mb and re-inserting the Netgear switch into the network to see if the problem if due to running some of the ports at 1000Mb.The systems on the network are running various versions of Linux (with different kernel versions, of course). Most are due for upgrades to get them current but I was planning on hitting the systems that had gigabit-capable ethernet interfaces thinking that a.) 100Mb speeds have been around forever and no problems have been seen when everything was running at 100Mb in the past and b.) the gigabit support for the older kernels should be better (one system only supports an MTA of 1500 max at 1000Mb).