Hardware :: Raid Setup Not Recognized After Updating RAM

My specs are as follows:

Motherboard:Asus Crosshair Formula IV
CPU:AMD Phenom� II X6 1090T Black Edition 3.2GHz
RAM:Corsair Vengeance 8GB DDR3 1600MHz CL8 Dual Channel Kit (2 x 4GB)
HDD: 1 Sata 750 GB Hard Drive
HighPoint 3120 PCI-E TrueRaid Controller, 2x250GB set as Mirroring.

So everything is working good. I have windows on the 750 GB Sata hard drive, and OpenSuse 11.3 on the Mirrored raid setup. I have grub as the bootloader, it loads windows and linux without error. So i have 8 gb of ram installed, but i have room for another 8 gb. This is where the error starts. After i install the other 8 gb of ram, which is corsair vengeance as well, windows will boot, but not linux. When i remove the newly installed ram, linux boots no problem. I tried putting the ram back in, then reinstalling linux again, but as i go through the setup, linux doesn't recognize the RAID setup. Like i can see it there, but i can't use it, partitions don't show up.Now i remove the install cd and tried to start linux again, still error. The error it gives me goes like this:

>Trying manual resume from /dev/disk/by-id<...>-part2
>resume device /dev/disk/by-id/<...>-part2 not found (ignoring)
>Waiting for device /dev/disk/by-id/<...>-part1 to appear: .............
>Could not find /dev/disk/by-id/<...>-part1
>Want me to fall back to /dev/disk/by-id/<...>-part1? (Y/n)

Wether i select Y or N, it takes me to a shell. I tried using fdisk in the shell to check if /dev/sda the linux setup has any partitions on it, and no it does not recognize any of it. When i use fdisk on /dev/sdb to list the partitions it works. So only the raid setup gets affected by the increase in RAM.