Networking :: IPTables And Routing On Untangle Box - Traffic Not Returned

I have an Untangle Box - which for those that don't know is a modified Debian Lenny used as a router, proxy, filter and much more - It has three physical interfaces on it eht0 (incoming traffic), eth1 (Outgoing to LAN after traffic filtered), and eth2 (Called a DMZ NIC, as Untangle can be used as a router). There is also a tun0 interface setup by Untangle for VPN (Not using the Openvpn in Untangle because I need bridged a bridged VPN and this is not an option in Untangles offering), a br0.eth setup by untangle to bridge eth0 and eth1 for traffic flow through as it is inline from router to switch and not acting as the router itself, and a br0 interface that I have setup by bridge script bridging eth2 and tap0 to run OpenVPN as a bridged VPN.

The routes on the machine are as follow:
Code:
untangle:~# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.100.0 * 255.255.255.0 U 0 0 0 br.eth0
192.168.1.0 * 255.255.255.0 U 0 0 0 br0
192.0.2.0 * 255.255.255.0 U 0 0 0 dummy0
192.0.2.0 * 255.255.255.0 U 0 0 0 utun
untangle:~#

I don't see a default route listed here, however, I do have Internet connectivity on the Untangle box itself. I also know that by script to bridge the tap0 and eth2 interfaces adds a default route through the gateway on the network that eth2 is connected to. So the lack of a default route is somewhat puzzling to me, I do have the gateway set through the web based admin interface Untangle offers.

The iptables rules are as follow:
Code:
untangle:~# iptables --list-rules
-P INPUT ACCEPT
-P FORWARD ACCEPT
-P OUTPUT ACCEPT
-N alpaca-firewall .....

There was an addition output rule in the alpaca-nat-firewall rule that said DROP outgoing interface eth2, I removed that rule with no change. I can ping out from the Untangle server to the eth2 LAN, I can access resources in the eth2 subnet. But I cannot get any reply from the server from anything either in that subnet or not. If I run iftop I can see the incoming traffic form my ping but the Server sends out no reply. I think this is a firewall issue. I can access the server by connecting to the IP assigned to the eth0/br0.eth interface which is in my main LAN. I am also attaching a crude diagram of the previous setup and the new setup (Previous setup used a different server for my bridged VPN).

Is there a rule I can add to ensure that traffic coming in on an interface goes out the same interface? Do I have a rule blocking incoming traffic to eth2/br0? Do I have one blocking sending out on eth2/br0? Do I have a default rule that is killing the traffic on eth2/br0 and I need to add an accept rule for traffic coming in on eth2/br0? I tried adding an accept rule for traffic coming in on br0, but it didn't work. I tried an output rule, but that didn't work, but I may have been bungling these rules as I do not fully understand the syntax and function and body of an iptables rule. The exact original iptables information before I modified anything can be viewed at [URL].