Fedora Networking :: Unable To Connect To Internet Whether By Wired Or Wireless In 15?
Aug 24, 2011
i have installed fedora 15(lovelock) on my lenovo z560 ideapad laptop. in fedora 15 lovelock internet is not working by wire or wireless. Network controller: Broadcom Corporation BCM4322 803.11a/b/g/n Wireless LAN Controller (rev 01)
[amit@localhost ~]$ ifconfig
em2 Link encap:Ethernet HWaddr 88:AE:1D:274:45
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
I installed ubuntu 9.10 on my laptop a few days ago and love the OS so far. However, initially i could only get internet connection though an ethernet cord. After much internet searching, i finally figured out how to get wireless internet. Unfortunately, in setting up wireless internet, I no longer have wired internet. The system doesn't seem to recognize my wired internet anymore. I'd like a scenario where i can connect to the internet both wired and wireless.
I recently installed Ubuntu 9.10 on my Dell Inspiron 1545 64-bit laptop. Before that I used Windows7. In Windows, the internet connection worked perfectly well. But after installing Ubuntu, I am unable to connect to the internet. The network-manager applet finally says that "You are disconnected". When I do the "ifconfig", I got no IP address.
So, I installed Ubuntu 9.04 in the same system. But the problem persists.
I gone through many posts in this forum but nothing was useful.
I am a beginner to ubuntu. I have installed ubuntu 10.04 on my laptop using wubi.When I am trying to edit the IP address using network editor,apply button is not highlighted.I managed to give IP as well as netmask through command prompt.But I am not able to give gateway and dns IP.Please help me configuring this.
I have just installed ubuntu 10.04 using the wubi installer to dual-boot my machine. Under ubuntu, I am not able to connect to the internet or my router. Everything works fine under windows. I have tried to find relevant information in the forums, but nothing seems to work for me. I have tried disabling ipv6, setting a static ip, but no go. ifconfig shows no IP, dhclient results in no DHCP offers and pinging my router's IP results in Network is Unreachable.
My laptop has been working fine with ubuntu 10.04, and earlier today it shut down after running out of battery. I came to use itr and discovered that the wifi icon had disappeared from the panel bar, and it won't connect to the wireless networkor via a wired connection.I have had a play around with this, tried ping -c5 google.comresult was:ping: unknown host google.comand ping -c5 22.214.171.124result: onnect:etwork is unreachable.I have other computers connecting to this network and know that it is working fine.
I am unable to connect to any network, wired or wireless. Network-manager and wicd are both gone, as in no longer installed. Please don't tell me to apt-get anything. I have no network connection. I have tried downloading packages for nm onto a usb stick only to find myself in dependency hell which ended with the impassible error "Requires installation of untrusted packages".
I'm trying to install Ubuntu 10.04 on my Toshiba A200-12U laptop (with an Atheros AR5007EG wireless card), but networking is being problematic.I entered Network Configurations and tried to get 'Auto eth0' working -- I went to Edit > IPv4 settings and filled in 'Addresses' with the details of my connection:
Address: 192.168.1.254 (the local IP of my router) Netmask: 255.255.252.0 Gateway: 126.96.36.199
newly installed fedora 15 is not able to connect to internet i have broadband connection with wireless modem my laptop is connecting to wireless modem network. but i am not able to configure pppoe connection on it PS: i am able to connect to internet when using wired connection from modem
I am unable to connect to the Internet using a wired connection. I was able to use the wired network yesterday. But I had problems with the flash player, so had to reinstall Ubuntu again. I am able to connect to Internet using wireless connection. But I need to connect to the wired connection. I am using Ubuntu 10. In my IPv4 settings, it is automatically set to DHCP, using which, I was earlier able to connect. But now it doesn't seem to be happening.
But there are other entries on the syslog that were recent.
I have recently installed Ubuntu lucid lynx and at my old house I had a regular cable modem (no wifi) and never used wireless internet. I would simply unplug the ethernet from the windows desktop plug it to my laptop and I was good 2 go.have recently moved and my roommate has a cable modem w/ wifi capabilities. When I plug in I am told that I am connected but......Nothing. dont know if the problem is due to the modem having wireless capabilities when my old one did not or the fact that my roommate has a win7 laptop that is connected via wifi etc. There have been a FEW times that I have walked out plugged in and everything has ran well. when I do plug in I look under connection information and I am told that I am connected at 100Mbps but whenever I try to visit a page I am out of luck. I define newbie (as far as Linux distros) and I have tried everything including going to work w/no sleep because I'm going through massive trial & errors
I've just installed 11.04 Natty on an old Laptop (Dell Lattitude C400) and am unable to connect to my home network (wired LAN connection, no wireless). The laptop previously had WinXP installed and was able to connect (I have also double checked the cables and ports and they're all functioning ok).
in linux world and have recently downloaded and installed ubuntu desktop 10.10i cannot connect to both wired and wireless ethernet on my laptopit tries to connect but fails in 30 seconds , it says"disconnected" while i am able to connect to the same in windows i have broadcom 4315 and i have tried both fwcutter and ndiswrapper but the problem persiststhe device id is 14e4:4315
I am a Ubuntu novice who recently shifted completely to Ubuntu 10.04 from Windows 7 on my Dell Inspiron Mini.
1. I am able to connect to the internet ('Wired') at home but when i plug in the internet cable at work it is not connecting. It gives me the message 'Unplugged, you are now disconnected'.
2. I tried installing the Wicd network manager. Even though there are wireless networks in range it doesnt show me the wireless networks (like it used to show in wiindows).
I have read through a long list of commands in the forums of commands to be executed and executed them all but couldnt connect. Is there anything basic that I am overlooking?
I thought that wired network should work once I plug in a network cable irrespective of the place. How come I am unable to connect to the network at work? I used to have a windows 7 partition and the net connected plug and play when i was in the windows side. I dont want to install Windows just for the internet at work again.
I've been running ubuntu for about 6 months, so i'm still abit of a newbie at linux but heres what im having issues with:I'm having troubles connecting to the internet on ubuntu, i have no problems connecting on xubuntu on the same machine. I can connect to my network but i cant access the internet on firefox or snaptic or any of that, but the weird thing is i can successfully ping address' in the terminal. I can also connect to my router config page in firefox using 192.168.0.1.
My internet worked perfectly about a month ago on this ubuntu install, so i cant figure out what i did to make it stop working. I think it may have something to do with the/etc/resolv.conf file because it only exists as /etc/resolv.conf.tmp and when i run "sudo dhclient wlan0" (or eth0) it says:
ubuntu@ubuntu:~$ sudo dhclient wlan0 Internet Systems Consortium DHCP Client V3.1.2 Copyright 2004-2008 Internet Systems Consortium.
currently running ubuntu 9.10, the internet connection im hooking up to is a router from a friends personal dish internet (were all deployed to Afghanistan). Here is all the static information that i need to input.now i have all this information input in windows 7 and it works fine since its all broken out exactly how it was given to me in the ipv4 settings page. wicd in ubuntu however wont use these settings.
i recently connected this router to mahh modem..http:[url]....before router connection i was able to connect to internet via "pppoeconf command" but now i am not able to connect to internet from ubuntu ..i am still using lan cable coming out or router to connect it with pc..
I just installed ubuntu 9.10 netbook remix (karmic koala) on my eeepc so im pretty new to linux but getting the hang of it. i was running windows before and the wireless and wired connections were perfectly fine. when i installed ubuntu, i chose it as my main system and wiped windows. now i cannot connect to the internet through the ethernet cable or wirelessly. even though i put in the right ip adress etc it doesnt work. the wireless doesnt even pick anything up so i uninstalled network manager. i installed wicd network manager and that doesnt pick anything either. BTW using a Ralink RT2860 network card.
I just switched from Ubuntu to Fedora 13 because I was unable to get Ubuntu to connect to wireless networks. I tried everything suggested in help and forums, and kept getting "Bad Password" with WICD and Network Manager. Now, with Fedora...I still can't connect.
Problem #1: The guide says to "...make sure that the relevant wireless interface (usually eth0 or eth1) is controlled by NetworkManager," and that I do this via: System>Administration>Network
However, there is no Network option under System>Administration.
Problem #2: I open Network Manager, which displays a list of networks. I click on mine, configure it with WPA and the right password, and it fails to connect: "The network connection has been disconnected."
I have just installed a fresh copy of 9.10 on an older Compaq nc6000 laptop. I need some help getting my Linksys WUSB600N wireless adapter to function properly.
I have "half-way" connectivity, meaning that I can see (and connect to) my home wireless network but I can't connect to the internet (unless I use the wired connection). I have installed NDIS wrapper - no change
I have installed Fedora 10 on my Intel system. I am not able to connect to internet from it. Mine is a broadband connection with ADSL+2 modem. I could connect once but afterwards it was deactivated and I got following bug report.
Component: system-config-network Version: 1.5.93 Summary: TBd036c2a6 re.py:237:_compile:TypeError: first argument must be string or compiled pattern Traceback (most recent call last): File "/usr/share/system-config-network/netconfpkg/gui/tonline.py", line 79, in on_generic_entry_insert_text if re.match(str, text): File "/usr/lib/python2.5/re.py", line 137, in match [Code]...
I am trying to connect to a wireless internet but can't. I previously used linux ubuntu and my wireless card worked. I am guessing that it should work with fedora then too. Is that correct? Do you have any suggestions as to what I should do to get the wireless internet working again on Fedora 12? Or what I should do to get usb wireless adapter to work.